Search

The applicability of using 2-furfural (2-FAL) and methanol as aging markers for synthetic ester impregnated paper insulation was investigated through laboratory aging experiments at temperatures of 80, 100 and 120 ?C. Methanol in the synthetic ester increased linearly with paper aging until degree of polymerisation (DP) reached 400. During this period concentration of methanol in oil was higher than that of 2-FAL, which proved the concept of using methanol to indicate early paper aging in the synthetic ester. However, the rate of methanol increase against the reduction of DP in the synthetic ester was about three times higher than that seen in mineral oil. This is due to a difference in the partitioning of the marker between oil and paper. Since the synthetic ester is more polar than the mineral oil, it attracted more methanol molecules from the paper, resulting in a higher concentration of methanol in oil for the same reduction of DP. In addition, a reduction in methanol was observed at the later stage of paper aging at 120 ?C. This could be due to either a change in the partitioning between oil and paper, or an esterification reaction which consumes methanol in the system. [ABSTRACT FROM PUBLISHER]

Furfural content in oil is a valuable indicator of cellulose paper degradation and is widely utilized in aging assessment for power transformers. However, with the same aging degree of insulation paper, the actual furfural content in oil is influenced by temperature because furfural partitioning behavior in the oil-paper insulation system of power transformers changes with temperature. Thus, correction of the temperature effect on furfural partitioning is crucial for accurate assessment of the aging of power transformers. In this research, oil-paper samples with different furfural contents were prepared through an accelerated thermal aging test. A furfural equilibrium experiment was conducted at different temperatures to construct a furfural partitioning diagram. The mass fraction of furfural in oil and paper was calculated. Results showed that the mass fraction of furfural in oil increases with temperature rising and aging deepening, which means that furfural tends to migrate from paper to oil at high temperatures and deep aging conditions. The change in furfural partitioning between oil and paper at different temperatures causes a deviation in paper aging assessment. To correct the temperature effect on furfural partitioning, a furfural correction factor was developed to normalize furfural contents in oil at different temperatures to a reference temperature. The furfural correction factor was verified by experimental data and then introduced into the relation between degree of polymerization of paper and furfural content of oil. Verification results showed that the corrected equation can enhance the accuracy of paper aging estimation at different temperatures. The findings of this work indicated temperature effect on furfural partitioning should be considered when determining the furfural thresholds and evaluating the aging condition of power transformers. [ABSTRACT FROM PUBLISHER]

The application of vibration-based condition monitoring methods to power transformers has shown the potential for detecting mechanical transformer failures. The ageing of winding insulation paper, which is a common problem in long-serving power transformers, affects both the electrical and mechanical strength of the windings. This paper is concerned with the vibration features of winding disks with aged insulation paper. The vibration characteristics of single-layer winding disks wrapped with insulation paper are investigated. By examining the vibration frequency responses of winding disks with different degrees of ageing of insulation paper, the effects of aged paper on the vibration behaviors of winding disks are demonstrated. The experimental results show that changes in the vibration responses of winding disks can be related to the ageing of insulation paper, and thus it is possible to detect this failure mode in a power transformer using a vibration-based method. A qualitative explanation for these changes is presented, using the degradation of the mechanical strength of the insulation paper. [ABSTRACT FROM AUTHOR]

The degradation of oil-impregnated paper induced by partial discharge (PD) seriously affects the life of power equipment. In order to investigate the relationship between partial discharge and the degradation of oil-impregnated paper, PD characteristics and trap parameters of the impregnated paper are measured. In this work, a cavity discharge model is adopted and samples with different degrees of polymerization (DP) are fabricated using thermally accelerated aging to simulate transformers with different lifetimes. For each sample, phase resolved partial discharge (PRPD) spectrograms are recorded for various partial discharge times. The characteristics of partial discharge are analyzed, and the trap parameters of specimens are obtained by the thermally stimulated depolarization current (TSDC) method. Following this, the microstructures of the samples are observed using a scanning electron microscope (SEM). It is found that the damaging breakdown process of oil-immersed paper can be divided into three stages: initial stage, developing stage and pre-breakdown stage. There also exist two levels of trap on the surface of oil-impregnated paper: shallow (0.10-0.59 eV) and relatively deep (0.60-0.90 eV) energy. Importantly, the thermal aging makes the trap energy deeper while electrical aging makes the trap energy shallower. [ABSTRACT FROM AUTHOR]