Search

Nowadays, reliability of power system is of great importance. Therefore, the condition of transformers as the expensive and critical components of a power system should be monitored and assessed. The dominant factor that causes limitation in transformers lifetime is the paper insulation. This paper aims to investigate the conspicuous influence of moisture content, especially in low oxygen and temperature on lifetime estimation under constant conditions, based on the results of previous experiments. Degree of polymerization (DP) is employed to quantify the effects of detrimental parameters with respect to their time-varying nature. This paper proposes a novel lifetime estimation-approach considering a yearly moisture growth for transformers. The results indicate different trend of DP profiles, which lead to an accurate lifetime estimation in comparison with DP obtained through ideal conditions. Furthermore, oscillations in the hot-spot temperature of transformers are demonstrated to have a negative effect on the lifetime. [ABSTRACT FROM AUTHOR]

The application of vibration-based condition monitoring methods to power transformers has shown the potential for detecting mechanical transformer failures. The ageing of winding insulation paper, which is a common problem in long-serving power transformers, affects both the electrical and mechanical strength of the windings. This paper is concerned with the vibration features of winding disks with aged insulation paper. The vibration characteristics of single-layer winding disks wrapped with insulation paper are investigated. By examining the vibration frequency responses of winding disks with different degrees of ageing of insulation paper, the effects of aged paper on the vibration behaviors of winding disks are demonstrated. The experimental results show that changes in the vibration responses of winding disks can be related to the ageing of insulation paper, and thus it is possible to detect this failure mode in a power transformer using a vibration-based method. A qualitative explanation for these changes is presented, using the degradation of the mechanical strength of the insulation paper. [ABSTRACT FROM AUTHOR]

The degradation of oil-impregnated paper induced by partial discharge (PD) seriously affects the life of power equipment. In order to investigate the relationship between partial discharge and the degradation of oil-impregnated paper, PD characteristics and trap parameters of the impregnated paper are measured. In this work, a cavity discharge model is adopted and samples with different degrees of polymerization (DP) are fabricated using thermally accelerated aging to simulate transformers with different lifetimes. For each sample, phase resolved partial discharge (PRPD) spectrograms are recorded for various partial discharge times. The characteristics of partial discharge are analyzed, and the trap parameters of specimens are obtained by the thermally stimulated depolarization current (TSDC) method. Following this, the microstructures of the samples are observed using a scanning electron microscope (SEM). It is found that the damaging breakdown process of oil-immersed paper can be divided into three stages: initial stage, developing stage and pre-breakdown stage. There also exist two levels of trap on the surface of oil-impregnated paper: shallow (0.10-0.59 eV) and relatively deep (0.60-0.90 eV) energy. Importantly, the thermal aging makes the trap energy deeper while electrical aging makes the trap energy shallower. [ABSTRACT FROM AUTHOR]

Heretofore, unlike HVAC transformers, there is not much experience in both insulation design guides and test methods for ultra HV converter transformers. This special insulation phenomenon is very prominent due to the complication of voltage applied on valve-side windings of converter transformers. There is a severe lack of empirical research on partial discharge in oil-paper insulation under the combined ACDC voltage. The study in this paper provides a timely research into the issues. Nine possible configurations, which intent to simulate different defects in the transformer, have been investigated. The PD inception voltages varied ratios of combined AC-DC voltages were conducted. The discharge magnitude and its relation with the applied voltage for selected four common configurations were obtained during voltage increasing and decreasing respectively, which presented the PD initiating process and also reflected the insulation behavior of dielectrics. Besides, the Finite Element Analysis Soft was used to propose the effect of morphology of electrode surface (3 dimensional roughness is approximately 0.03 mm) on PD characteristics, which is very lacking in the previous references. The roles of DC and AC component in PD characteristics were discussed in the context of the relevant work in literatures. [ABSTRACT FROM AUTHOR]