Search

In this paper, the influence of partial discharges (PD) on the subsequent dielectric properties of oil-impregnated paper (OIP) is investigated. Dielectric frequency response (DFR) of OIP is investigated at varied levels of moisture, thermal aging, temperature, oil conductivity and electrode material, to allow comparison of these influences. It is shown that PD activity inside OIP can significantly change the real and imaginary parts of permittivity of the paper layers, especially in the frequency range below 100 Hz. It is shown that even if the PD activity is concentrated on a few percent of the test sample, the real part of permittivity measured on the entire sample after a few tens of hours of PD activity can increase up to 10 times at very low frequencies (∼ 1 mHz) and the imaginary part of the permittivity can increase up to 100 times at low frequencies (∼ 1 Hz). The change of the real and imaginary parts of permittivity due to PD activity is permanent. It is very similar to the change caused by thermal aging, and somewhat similar to the change caused by moisture and higher oil conductivity. It is also shown that the dissipation factor of OIP in contact with copper and brass increases, even in the absence of PD, but contact with aluminum and stainless steel has no influence on DFR of OIP. The results suggest that the influence of PD can be significant when estimating the moisture content or the level of thermal aging of OIP with DFR method. [ABSTRACT FROM PUBLISHER]

The oil-paper insulation of valve-side windings in a high voltage direct current (HVDC) converter transformer is subjected to both complicated voltage and severe thermal stresses. Partial discharge (PD) occurring in oil-paper bounded cavities is influenced by voltage stress type as well as temperature. This paper presents PD behaviors in an oil-paper bounded gas cavity under pulsating DC voltages. The voltage across the gas cavity and PD inception voltages at different test conditions are analyzed. Influences of temperature on statistical PD distributions and parameters are also presented. A numerical model is used to interpret PD behaviors under pulsating DC voltages and various temperatures. Experimental results and theoretical statements show that the temperature exhibits a great influence on the behaviors of cavity discharge under pulsating DC voltages. Volume resistivity, gas pressure, charge decay time constant, and electron generation rate are the primary parameters influencing PD behaviors at different temperatures. [ABSTRACT FROM PUBLISHER]

Heretofore, unlike HVAC transformers, there is not much experience in both insulation design guides and test methods for ultra HV converter transformers. This special insulation phenomenon is very prominent due to the complication of voltage applied on valve-side windings of converter transformers. There is a severe lack of empirical research on partial discharge in oil-paper insulation under the combined ACDC voltage. The study in this paper provides a timely research into the issues. Nine possible configurations, which intent to simulate different defects in the transformer, have been investigated. The PD inception voltages varied ratios of combined AC-DC voltages were conducted. The discharge magnitude and its relation with the applied voltage for selected four common configurations were obtained during voltage increasing and decreasing respectively, which presented the PD initiating process and also reflected the insulation behavior of dielectrics. Besides, the Finite Element Analysis Soft was used to propose the effect of morphology of electrode surface (3 dimensional roughness is approximately 0.03 mm) on PD characteristics, which is very lacking in the previous references. The roles of DC and AC component in PD characteristics were discussed in the context of the relevant work in literatures. [ABSTRACT FROM AUTHOR]