Search

Motor current signature analysis (MCSA) based detection of rotor cage faults (RFs) in medium-high voltage induction motors has become common in the field due to its low-cost remote monitoring capability. However, low-frequency load oscillations (LOs) in applications that employ speed reduction couplings can induce frequency components in the vicinity of that of RFs. It has been reported that false-positive or -negative RF indications can be produced with the MCSA, if the frequency components produced by RF and LO overlap. There, recently, have been studies on discriminating RF and LO; however, the case where two harmonic components overlap at the same frequency, which is the most difficult and serious case, has not been investigated. In this paper, a spectrum analysis of instantaneous active and reactive power is applied, and it is shown that RF and LO can be separated for the case where the MCSA fails due to the overlap in the two spectral components. An experimental study performed on a 380 V motor with a speed reduction gear shows that RF and LO can be reliably detected and separated for avoiding false RF indications. [ABSTRACT FROM PUBLISHER]

The capacitive-coupling grid-connected inverter (CGCI) is coupled to the point of common coupling via a second-order LC branch. Its operational voltage is much lower than that of a conventional inductive-coupling grid-connected inverter (IGCI) when it serves as a multifunctional inverter to compensate reactive power and transfer active power simultaneously. It is a promising solution for microgrid and building-integrated distributed generator systems. A quasi-proportional-resonant (quasi-PR) controller is applied to reduce the steady-state current tracking errors of the CGCI in this paper. The quasi-PR controller generates the voltage reference for use of carrier-based pulse-width modulation, which can effectively reduce output current ripples. The second-order coupling impedance of the CGCI causes its modeling and controller design to differ from that of the conventional IGCI. A comprehensive design method for the quasi-PR controller in a CGCI is developed. The quasi-PR controller is also compared with a proportional-integration current controller. Simulation results are provided to verify the effectiveness of the quasi-PR controller and its design method in a CGCI. The current tracking errors are greatly reduced when the quasi-PR controller rather than the proportional-integration controller is applied. Experimental results are also provided to validate the CGCI as a multifunctional grid-connected inverter. [ABSTRACT FROM PUBLISHER]