Search

The multigap gas switch has been widely used in liner transformer drivers (LTDs), but there is still room for improvement on its self-breakdown and triggering characteristics. In this paper, based on the circuit model of the six-gap gas switch, the gap voltage distribution during the charging and triggering process is analyzed, and the optimization on self-breakdown and triggering characteristics by mounting resistors and capacitors in parallel with switch gaps are theoretically and experimentally investigated. The results indicate that compared with the original switch, when the self-breakdown voltage is about ±90 kV, the standard deviation is reduced from 7.5 to less than 3 kV; for a charging voltage of ±80 kV and by operating at 60% working coefficient, when the negative trigger voltage is 75 kV, the jitter of the switch is reduced from 6.1 to 1.4 ns. [ABSTRACT FROM AUTHOR]

The quench protection switch (QPS) is an indispensable component ensuring the safety of the magnet coils of a superconducting Tokamak when a quench happens. In this paper, the second commutation process of a QPS based on artificial current zero is investigated. In this process, the current, which has already transferred from the bypass switch to the main circuit breaker, is forced to commutate from the vacuum circuit breaker (VCB) to the discharge resistor by the countercurrent. An LC oscillating circuit is applied to generate oscillating current to simulate the direct current near its peak which is about 20 kA. The countercurrent with frequencies of 500 and 1000 Hz is provided by a commutation branch. The equivalence of the experimental interrupting process compared with the practical situation is analyzed. Two kinds of vacuum interrupters of the VCB are used in experiments. One kind is equipped with contacts generating transverse magnetic field, and axial magnetic field contacts are used in another one. The experimental results indicate that the initial process of the vacuum arc before injecting the countercurrent has crucial impacts on the interruption performance. The countercurrent with the frequency of 500 Hz is easier to interrupt the current than the case of 1000 Hz. [ABSTRACT FROM AUTHOR]

This paper reports on the study of physical processes in a high-current vacuum arc shunted by semiconductor elements. The switching dynamics between a vacuum circuit breaker (VCB) and an assembly of several semiconductor elements connected in parallel to the VCB is investigated. The breaking capacity of a VCB-thyristor system is analyzed. It is found that at the instant of current switching, the arc can operate at a rather low voltage of 8–10 V. It is shown that there exists a certain limiting mode close to the conditions for current switching. In this mode, at least two cathode spots are observed. [ABSTRACT FROM PUBLISHER]

Switching time jitter is an important property to consider when selecting closing switches for pulsed-power systems. The corona-stabilized switch (CSS) is identified as an interest for low-jitter systems, in particular for systems where a high-repetition rate is required. In this paper, a commercial CSS is studied and its operating conditions are determined. [ABSTRACT FROM AUTHOR]