Search

The fault-tolerant control method of dual three-phase permanent-magnet synchronous motor (PMSM) drives has gained more and more attention in some applications, such as aircraft system and offshore wind energy system. In this letter, the reason for the torque ripple caused by the standard control method has been investigated in view of the frequency domain after the occurrence of a single open-phase fault. Based on the theoretical analysis, a universal control scheme has been proposed for the dual three-phase PMSM drives with two isolated neutral points, which can be implemented under either healthy condition or fault condition. The key is to modify with a closed-loop controller on harmonic subspace with the notch filter. The proposed method not only realizes the seamless transition between two operation conditions without fault diagnosis but also avoids the reconfiguration of the control structure. Moreover, the system optimization of the minimum copper loss under postfault condition has been integrated into the proposed method. The experimental results are presented to illustrate the effectiveness of the proposed method. [ABSTRACT FROM AUTHOR]

Position sensorless control of interior permanent magnet synchronous motors (IPMSMs) is of great importance for the sake of the cost reduction and robustness improvement. An improved position sensorless method based on adjustable high-frequency (HF) square-wave voltage injection has been proposed for the IPMSM drive under zero- and low-speed regions. The general detection method of position from positive- and negative-sequence HF current response has been developed by the simple algebraic operations of data at some adjacent sampling instants. In addition, the proposed method not only can retain the advantage of the removal of low-pass filters in current feedback but also can increase the voltage margin of inverter with adjustable frequency setting of HF signal compared with existing square-wave voltage injection methods. Comprehensive experimental results have been given to verify the proposed theoretical analysis. [ABSTRACT FROM AUTHOR]

In this article, a minimum-copper-loss fault-tolerant control scheme is proposed for open-phase fault and open-switch fault of dual three-phase permanent magnet synchronous motor (DT-PMSM) drives. Both the winding configurations of isolated neutral points and connected neutral points are studied in this article. In conventional minimum-copper-loss fault-tolerant control schemes, the constraints of sinusoidal phase currents result in insufficient copper-loss reduction. Different from them, the current references with the theoretically lowest copper losses are first derived and applied for different fault cases of DT-PMSM drives without using any unnecessary constraints in the proposed fault-tolerant control scheme. Thus, all phase currents in the proposed minimum-copper-loss fault-tolerant control scheme are optimized to be nonsinusoidal waveforms. Besides, the copper losses are further reduced by fully utilizing the remaining healthy switch in the faulty inverter leg for the open-switch fault of DT-PMSM drives with the proposed scheme. It has been theoretically and experimentally proved that the proposed fault-tolerant control scheme can reduce copper losses than all existing fault-tolerant schemes for both open-phase fault and open-switch fault in typical two-level voltage-source-inverter-fed DT-PMSM drives. [ABSTRACT FROM AUTHOR]

Pulsewidth-modulated (PWM) current-source converters (CSCs) have the features of simple configuration, reliable short-circuit protection, and sinusoidal ac output voltages. The conventional space-vector modulation (SVM) scheme usually generates high-magnitude low-order harmonics in CSCs with low switching frequency. In this article, two modified SVM schemes, namely MSVM1 and MSVM2, are proposed to improve the harmonic performance for PWM CSCs in the high-power applications with low switching frequencies. The MSVM1 scheme focuses on eliminating the average dwell-time error of current vectors within each sampling period, while the MSVM2 scheme is targeted to achieve the accurate dwell time of current vectors as that of the natural sampling-based SVM scheme. The theoretical analysis and the calculation equations of dwell time are derived for both MSVM1 and MSVM2. The experiments are given to verify the effectiveness of the two modified SVM schemes in improving the harmonic performance of high-power CSCs with low switching frequencies. [ABSTRACT FROM AUTHOR]

In this article, the control strategy is studied for the neutral-point-clamped three-level inverter-fed dual three-phase permanent-magnet synchronous motor (PMSM) drive with low switching frequencies. An interleaved finite-control-set model predictive control (MPC) scheme is proposed, where a two-layer MPC is designed to solve the multiobjective optimization problem. The two sets of windings in PMSM are sampled and controlled in an interleaved way so that the control delay and the prediction horizon of the drive system are reduced by half. Moreover, the proposed interleaved control scheme increases the equivalent sampling and control frequency from the perspective of the whole drive system, and thus provides better steady-state performance and dynamic performance. With the switching states of one inverter remaining unchanged, the cross traversal of vector candidate sets between two sets of windings is avoided, and the computational burden can be reduced effectively. Experimental results are given to verify the validity and effectiveness of the proposed interleaved control scheme. [ABSTRACT FROM AUTHOR]

The rotor flux linkage of permanent-magnet synchronous motor (PMSM) is of great importance for monitoring and high-performance control. However, most of the existing online estimation methods need prior knowledge of other PMSM parameters such as stator resistance and dq axis inductance, which are difficult to realize in the rank-deficient models of electrical machines. This article proposes a simple online estimation method of rotor flux linkage for the dual three-phase surface-mounted PMSM (SPMSM) drives with the assistance of injected position offset. The independent estimation model has been developed for the rotor flux linkage by appropriate setting of positon offset between two sets of three-phase windings of dual three-phase SPMSM drives. The proposed method not only has little influence on the output torque and high signal-to-noise ratio for observation, but also offers the superior performance in estimation accuracy irrespective of the influence of VSI nonlinearity. In addition, the proposed position-offset-based method is suitable for the full-speed region including the field-weakening operation. Finally, comprehensive experimental results are presented to verify validity of the proposed method under different working conditions. [ABSTRACT FROM AUTHOR]

This letter proposes a four-leg current-source inverter (CSI) fed three-phase motor drive. Different from the previous four-leg CSI inverter, the proposed configuration introduces the fourth leg in CSI, which connects to the neutral point of the motor through an extra output filter capacitor. Therefore, the proposed configuration can not only reduce the common-mode voltage (CMV) under the normal condition, but also provide the fault-tolerant operation ability under open-circuit faults in windings and switches. The dedicated space vector modulation (SVM) strategies have been designed. Compared with prior research on CMV reduction, the four-leg method has the full range of modulation index and will not increase any harmonics in the currents. Meanwhile, the fault-tolerant ability is offered, which can further enhance the reliability of the motor drive. A laboratory prototype has been built to experimentally verify the effectiveness of the proposed motor drive topology and the control schemes. [ABSTRACT FROM AUTHOR]

The magnetic circuit has been a popular and powerful tool to analyze the magnetic field in electromagnetic devices for a long history. However, in the conventional magnetic circuit there is only one kind of component namely reluctance, which cannot analyze the phase shift or the amplitude attenuation of the alternating flux in electromagnetic devices. In this article, a new physical concept of magnetic-inductance is proposed, based on which the alternating-flux magnetic circuit theory including two kinds of components namely reluctance and magnetic-inductance has been developed. Furthermore, the virtual magnetic power is defined as the analogue of electric power, and the magnetoelectric power law is derived for magnetic circuits. Using the proposed magnetic circuit theory with magnetic-inductance, the relationship between the electric power and the virtual magnetic power is revealed and the long-lasting confusions in previous magnetic circuit methods, i.e., power calculation and phase shifts of magnetic variables, are clarified. By experiments, the magnetic-inductance and the magnetoelectric power law are validated, and their applications in eddy current loss analysis and B-H curve estimation in magnetic materials are demonstrated. [ABSTRACT FROM AUTHOR]

Inthis article, a half-centralized open-winding primary permanent-magnet linear motor (HCOW-PPMLM) drives system is proposed, in which two independent voltage-source-inverters (VSIs) and one common VSI are required to supply two open-winding movers. Compared to the traditional open winding motor topology, the proposed topology requires less half-conductor switches, which can reduce the construction cost, system volume, system weight, operation and maintenance cost, and failure rate. To achieve high-performance operation, a collaborative control is proposed for the proposed topology. Based on the principle that minimizes maximum voltage of VSIs, the voltage distributor in the proposed collaborative control is designed to maximize the dc bus voltage utilization. The effectiveness of the proposed topology and the proposed collaborative control have been verified by experimental results. The proposed topology is also compared with conventional open-winding PPMLM topology by variable speed and load experiments. [ABSTRACT FROM AUTHOR]

In this article, a dual-vector located model predictive control (DL-MPC) method based on a single dc-link current sensor is proposed for the permanent-magnet linear motor drive system. In DL-MPC, the phase currents are reconstructed by sampled dc-link current and selected active voltage vector (VV). Meanwhile, the sunk number of phase current is defined to evaluate the accuracy of current reconstruction. The first-optimal and second-optimal VVs are determined by dual-vector location. The second-optimal VV is selected for the voltage source inverter when the sunk number exceeds the threshold. Compared with traditional MPC schemes, DL-MPC has smaller current tracking error and better dynamic performance. Meanwhile, DL-MPC has more accurate current reconstruction and lower computation burden than that of the traditional MPC. The effectiveness of DL-MPC is verified by both theoretical analysis and experimental results. [ABSTRACT FROM AUTHOR]

This letter proposes a fast current control scheme for ac drives by minimizing the latency from current sampling to the updation of a pulsewidth-modulation (PWM) command. By reconstructing the architecture of a linear controller, the minimal necessary steps to obtain the output voltage are deduced as the primary calculation, and the other computation work of the current loop is done in the postcalculation after updating the PWM command. With the proposed method, the computational delay is reduced with negligible loss in the available modulation index, and a higher stability margin or system bandwidth is realized. Also, the developed controller structure exhibits inherited antiwindup characteristics. The technique has been validated by experimental investigations on a permanent magnet synchronous motor. [ABSTRACT FROM AUTHOR]