Search

This paper investigates a wireless powered mobile edge computing (MEC) network where a hybrid access point (H-AP) serves energy-constrained devices. For such a wireless powered MEC network, the H-AP first transmits wireless information and energy simultaneously in the downlink. Then, by utilizing the harvested energy, the device processes both its local data and the received data from the H-AP. In this system, we minimize the latency by jointly optimizing the power splitting ratio of rectifiers, the data offloading power, the local computing frequency, and the data offloading ratio at the device. By applying a polyblock outer approximation procedure, we propose an algorithm which guarantees the optimal solution. Simulation results verify the efficiency of the proposed algorithm compared to conventional schemes. [ABSTRACT FROM AUTHOR]

This paper studies a novel design of user pairing and resource allocation in a simultaneous wireless information and power transfer (SWIPT)-enabled cooperative non-orthogonal multiple access (NOMA) system with coexisting power-splitting (PS) and time-switching (TS) users. In this system, near NOMA users (NUs) that are close to a source can assist the communications between the source and far NOMA users (FUs) using the energy harvested by either PS or TS strategy. The design aims to maximize the sum-rate of the system by optimizing user pairing and power allocation between NUs and FUs as well as performing PS and TS control at NUs, while guaranteeing the target data rates and the minimum harvested energy requirements of users. Since the joint design is formulated as a non-convex mixed-integer non-linear programming (MINLP) problem that is challenging to tackle, we propose a two-step user pairing and resource allocation algorithm. Specifically, we decouple the original problem into an inner resource allocation problem and an outer user pairing problem. For the inner problem, we propose successive convex approximation (SCA) and block coordinate descent (BCD)-based algorithms to perform power allocation as well as PS and TS control iteratively, with the algorithms’ convergence being theoretically proved. By exploiting the characteristics of the outer problem of user pairing, this problem is well tackled by the Hungarian algorithm. Simulation results demonstrate the proposed joint design yields better performance gains than the existing schemes. [ABSTRACT FROM AUTHOR]

The multi-UAV network is promising to extend conventional networks by providing broader coverage, and better reliability. Nevertheless, the broadcast nature of wireless signals, and the broader coverage expose multi-UAV communications to the threats of passive eavesdroppers. Recent studies mainly focus on securing a single legitimate link, or communications between a UAV, and multiple ground users in one/two-UAV-aided networks, while the physical layer secrecy analysis for hierarchical multi-UAV networks is underexplored. In this paper, we investigate a general two-tier UAV network consisting of multiple UAV transmitters (UTs), and multiple UAV receivers (URs) in the presence of multiple UAV eavesdroppers (UEs). To protect all legitimate UT-UR links against UEs at the physical layer, we design a two-stage framework consisting of a UT-UR association stage, and a cooperative transmission stage. Specifically, we formulate the secure transmission problem into a many-to-one matching game followed by an overlapping coalition formation (OCF) game, taking into account the limited capabilities, and the throughput requirements of URs, as well as the transmission power constraints of UTs. A matching algorithm, and an OCF algorithm are proposed to solve these two sequential games whose convergences, and stabilities are guaranteed theoretically. Simulation results show the superiority of our algorithms, and the effectiveness of our two-stage game framework in the terms of secrecy performance. [ABSTRACT FROM AUTHOR]

This paper studies the information-energy ($\mathrm{I}$ - $\mathrm{E}$) region for simultaneous wireless information and power transfer (SWIPT) networks in mobility scenarios, where a moving transmitter simultaneously transmits information and power to a fixed receiver, and the receiver adopts power splitting (PS) receiving architecture. In order to characterize the tradeoff between the received information and harvested energy, the $\mathrm{I}$ - $\mathrm{E}$ region is defined, and corresponding optimization problems are formulated to explore the system $\mathrm{I}$ - $\mathrm{E}$ regions by jointly optimizing the transmit power at the transmitter and the PS ratio at the receiver with three popular energy harvesting (EH) models, i.e., traditional linear EH model, the logistic nonlinear EH model and the piecewise nonlinear EH model. Particularly, to efficiently solve the nonconvex optimization problem with the logistic nonlinear EH model, a successive convex approximate (SCA)-based algorithm is proposed, which is able to characterize the lower bound of the $\mathrm{I}$ - $\mathrm{E}$ with low complexity. To solve the optimization problems with the linear and piecewise EH models, as they are convex, some closed and semi-closed solutions are derived by using Lagrange dual method and KKT conditions. Numerical results show that compared with the $\mathrm{I}$ - $\mathrm{E}$ regions under the linear and piecewise EH models, that under the logistic nonlinear EH model is smaller due to the limitations of practical EH circuit features. Moreover, with a fixed moving speed, when the transmit power is relatively large, the logistic nonlinear EH model can be replaced with the piecewise one due to the relatively small gap between their achieved $\mathrm{I}$ - $\mathrm{E}$ regions. Additionally, for a fixed moving track length, the higher moving speed yields the smaller $\mathrm{I}$ - $\mathrm{E}$ region with all three EH models. [ABSTRACT FROM AUTHOR]

In this paper, we study the distributed precoding problem for simultaneous wireless information and power transfer (SWIPT) in decode-and-forward (DF)-based multiple-input–multiple-output (MIMO) relay networks. The system model considered here consists of a source, a relay, an information decoding (ID) receiver, and an energy harvesting (EH) receiver, all mounted with multiple antennas. Since full channel state information (CSI) is usually unavailable, a practical scenario, where only local CSI is required, is considered in this paper. Such a practical scenario naturally constitutes a noncooperative game, where the source and the relay can be regarded as two rational game players. With properly designed utilities, it can be further shown that the existence and uniqueness of the pure-strategy Nash equilibrium (NE) of the proposed game can both be guaranteed under some mild conditions. Therefore, a distributed iterative precoding algorithm can be developed based on the best-response dynamic to obtain the unique NE solution for the proposed game. Moreover, a proximal-point-based regularization approach is also pursued to ensure the convergence of the proposed algorithm without requiring special restrictions on the channel ranks. Numerical simulations are also provided to demonstrate the proposed algorithm. Results show that our algorithm can converge quickly to a satisfactory solution with guaranteed convergence. [ABSTRACT FROM PUBLISHER]

A cognitive radio is a smart software-defined radio that can adapt its transmission parameters, such as transmit power level and modulation type, based on the wireless channel conditions. In this paper, we introduce a joint power allocation and constellation design algorithm for cognitive radios assuming spectrum sensing imperfections. The proposed algorithm minimizes the symbol error rate of the secondary user by designing optimized 2-D constellation points and assigning transmit power levels. The constellation points are assumed to be equally probable with zero-mean and unit average symbol energy. The transmit power levels are assigned such that they do not exceed a predefined maximum transmit power threshold, and that the interference resulting from the secondary user to the primary user does not exceed a predefined value. The outcomes of the proposed algorithm, which are constellation points and transmit power levels, can be stored in a lookup table that the secondary user can access to adapt its transmission parameters to the environment based on sensing decisions, maximum transmit powers, and interference levels allowed by the primary user. Numerical results are provided to show the symbol error rate performance of the designed constellation points and compared to the performance of the conventional square grid M-ary quadrature amplitude modulation under the same operational parameters. [ABSTRACT FROM PUBLISHER]

Device-free wireless localization (DFL) is a technique that can locate a target by analyzing its shadowing effect on wireless links, which causes the variation of link measurements, while removing the requirement of equipping the target with a device. It can provide fundamental data for pervasive computing, smart environment, and traffic surveillance applications. The observation model, which represents the relationship between wireless link measurement and target location, is very important for DFL, since it characterizes the shadowing effect of the target on wireless links and, therefore, determines the performance of the DFL system. In this paper, inspired by measurement results, we propose a saddle surface (SaS) model to describe the shadowing effect. The SaS model characterizes the elaborate information within the spatial impact area and provides more useful observation information for the location estimation algorithm. We incorporate the SaS model into the particle filter framework for location estimation. Extensive experiments in indoor and outdoor scenarios are carried out to evaluate the performance of the proposed schemes. The tracking errors of 0.78 and 0.21 m in the given two scenarios demonstrate the better performance of the proposed SaS model compared with existing models. [ABSTRACT FROM AUTHOR]