Search

Abstract: As we know, the mean temperature difference approach perfectly solves the problem of thermal design of a two-fluid heat exchanger. However, so far, the equivalent method has not been found for that of three-fluid heat exchanger. In this paper, a mean temperature difference method called IMTD (integral-mean temperature difference) is developed in detail for a parallel stream three-fluid heat exchanger with two communications. It includes the derivation of IMTD formulae, the illustration of design and simulation procedures of IMTD thermal model, the corresponding exemplary calculations and discussion, and the validation of IMTD thermal model. The research shows that the derived IMTD formulae and accelerated method proposed in the present IMTD model significantly improve the design process in the past analytical models. It realizes a fast convergence which is usually within 10 steps for all parallel stream flow arrangements. Moreover, the present model has the same accuracy as past exact analytical models and simultaneously can be comparable to past approximate analytical models in simplicity. [Copyright &y& Elsevier]

Abstract: This article analyzes parallel flow microchannel heat exchangers with non-adiabatic thermal condition imposed on the wall separating the fluids and the ambient. For purposes of analysis, a thermal model comprising of two governing equations, one for each of the fluids, is developed and analytically solved to obtain equations for calculating the axial temperature and thereby the effectiveness of both fluids. Provision is provided in these equations for the temperature of the ambient interacting with the hot fluid to be different from that associated with the cold fluid. Analytical equations for determining the heat transfer between the individual fluids and the respective ambient as well as that between the fluids are also developed in this paper. The temperatures/effectiveness of the fluids depend on parameters such as NTU, fluid heat capacities, thermal resistance between the individual fluid and the respective ambient and ambient temperatures. In addition, under certain operating conditions the phenomenon of temperature-cross is observed. Depending on the ambient temperatures, increase in NTU will continuously improve the effectiveness of one the fluids; the effectiveness of the other fluid over the same NTU range increases before peaking and subsequent decrease. Equations for determining the NTU at which this peak value in effectiveness occurs are also provided. An unbalanced flow microchannel heat exchanger with the hot fluid having the lowest heat capacity has better effectiveness than when the cold fluid has the lowest heat capacity. [ABSTRACT FROM AUTHOR]