Search

Highlights • 1 Five kinds of hydrophobic DESs were designed and prepared for the first time. • 2 The prepared DESs showed high extraction efficiency for formaldehyde (HCHO). • 3 The DES was applied to extract and determine of HCHO in biological and gas samples. • 4 Hydrophobic DESs based VA-LLME combined with HPLC method was developed. Abstract Hydrophobic deep eutectic solvents (DESs) are a new class of green solvents, and their research and application are a brand new area. So far, only a few hydrophobic DESs have been reported as extraction solvents. In this paper, five kinds of hydrophobic DESs composed of trioctylmethylammonium chloride and hydroquinone, 4-phenylphenol or 4-cyanophenol are designed and prepared for the first time. Melting point / glass transition temperature and density are also determined for these DESs. Coupled with HPLC, these hydrophobic DESs have been used as extractants in vortex-assisted liquid-liquid microextraction for the selective enrichment and indirect determination of formaldehyde. The optimization of reaction and extraction conditions, such as pH value, reaction time and temperature, concentration of 2,4-dinitrophenylhydrazine, type and dosage of the extraction solvent, speed and time of vortex, salt addition and centrifugation time are investigated in detail. It is found that under the optimized experimental conditions, the calibration curve of this method is linear in the range of 1.0–200.0 μg L−1 with the linear correlation coefficient (r2) of 0.9994. The limit of detection (S/N = 3) and limit of quantification (S/N = 10) are 0.2 μg L−1 and 1.0 μg L−1, and the intra-day and inter-day precision (RSD, n = 5) are 1.1% and 3.5%, respectively. The interference of some common coexisting ions and neutral molecules have been also tested. The proposed method has been successfully used for the determination of formaldehyde from biological and indoor air samples. The recovery of formaldehyde is in the range from 83.1% to 104.4%, and the relative standard deviation is lower than 5.9%. Furthermore, the analytical parameters of the proposed method have been compared with other extraction and microextraction methods. [ABSTRACT FROM AUTHOR]

• Novel AA-LLME based on solidification of floating DES method was developed. • DESs with low viscosity, density and melting point near room temperature were used. • Central composite design was used for the method optimization. • This method is simple, low cost, centrifugal-free, and environment friendly. For this work, a novel air-assisted liquid-liquid microextraction based on solidification of floating deep eutectic solvent (AA-LLME-SFDES), coupled with a high performance liquid chromatography (HPLC) method was developed for the detection of benzophenone and salicylate ultraviolet filters in water samples. Three types of fatty acid-based hydrophobic deep eutectic solvents (DESs) with low viscosity, low-density, and melting point close to room temperature were prepared and employed as extraction solvents. This air-assisted liquid-liquid microextraction was carried out in a glass centrifuge tube. Subsequently, the glass tube was introduced into ice-water bath and held for 3 min, during which the upper DES phase was solidified. The water phase was easily extracted using a syringe equipped with a long needle, and later, the glass tube was removed from ice-water bath. The solidified DES phase was immediately melted at room temperature and used for HPLC analysis. The response surface methodology was employed to optimize some influencing parameters such as the volume of the extraction solvent, the pH value of sample solution, the number of extraction cycles, and the addition of salt. A quadratic model, namely a central composite design, was used to replace the conventional single factor analysis. It was found that under optimal conditions, the limits of determination and quantification were 0.045–0.54 µg L−1 and 0.15–2.0 µg L−1, respectively. The relative standard deviations for inter-day (n = 5) and intra-day (n = 5) precision were ≤ 4.2%, whereas the enrichment factors for the ultraviolet filters were obtained from 41 to 50. Furthermore, this novel method was successfully employed for the detection of benzophenone and salicylate ultraviolet filters from real water samples. The recoveries ranged from 87.5% to 105.8%, whereas the RSDs were lower than 3.6%. [ABSTRACT FROM AUTHOR]