Search

Industrial single-storey buildings are the most diffuse typology of steel construction located in Italy. Most of these existing buildings were erected prior to the enforcement of adequate seismic provisions; hence, crucial attention is paid nowadays to the design of low-impact retrofit interventions which can restore a proper structural performance without interrupting productive activities. Within this framework, an existing industrial single-storey steel building located in Nusco (Italy) is selected in this paper as a case-study. The structure, which features moment resisting (MR) truss frames in both directions, is highly deformable and presents undersized MR bolted connections. Structural performance of the case-study was assessed by means of both global and local refined numerical analyses. As expected, the inadequate performance of connections, which fail due to brittle mechanisms, detrimentally affects the global response of the structure both in terms of lateral stiffness and resistance. This effect was accounted for in global analyses by means of properly calibrated non-linear links. Thus, both local and global retrofit interventions were designed and numerically investigated. Namely, lower chord connections were strengthened by means of rib stiffeners and additional rows of M20 10.9 bolts, whereas concentrically braced frames (CBFs) were placed on both directions' facades. Designed interventions proved to be effective for the full structural retrofitting against both seismic and wind actions without limiting building accessibility. [ABSTRACT FROM AUTHOR]

Seismically pre-qualified beam-to-column joints guarantee large ductility in seismic scenarios thanks to the effectiveness of the design rules and technological requirements that are devoted to avoiding the failure of brittle components (i.e., bolts and welds). However, their performance under different severe actions like those induced by fire has not been properly investigated. Therefore, a parametric study based on finite element simulations has been carried out with the aim to verify the effectiveness of local details of seismically prequalified joints under fire. Finite element analyses were carried out on beam-to-column assemblies sub-structured from a reference archetype building accounting for both material and geometrical imperfections. The bolts' internal actions were monitored in all the investigated specimens varying the applied vertical loads. The results show that the seismic design rules adopted to size the bolts are effective to resist the large increase in shear forces in the bolts occurring under fire. Thus, the investigated joints provide satisfactory ductility and rotation capacity at high temperature preventing the failure of bolts; further analysis could be conducted to investigated the fire performance of the investigated joints in a seismic scenario. [ABSTRACT FROM AUTHOR]

The seismic response of steel moment resisting frames (MRFs) is influenced by the behavior of joints. Within the ongoing research project "FUTURE"(Full-scale experimental validation of steel moment frame with EU qualified joints and energy efficient claddings under Near fault seismic scenarios), shake table tests will be carried out on a two-story one bay MRF equipped with different types of prequalified beam-to-column joints. In order to design the experimental campaign, preliminary numerical simulations have been carried out to predict the seismic performance of the experimental mock-up in terms of distribution of damage, transient and residual interstory drifts. In this paper the main modeling assumptions and the results of the seismic analyses are shown and discussed. In particular, the response of joints was systematically investigated by refined finite element (FE) simulations and their behavior was taken into account in the global structural performance by means of both concentrated plastic hinge and distributed plasticity models. Both static and dynamic non-linear analyses show in which terms the type of models for plastic hinges influences the results. The modeling approach plays a key role only at very high seismic intensity where large ductility demand is imposed. In addition, changing the type of joints has less influence on the overall response of the frame. [ABSTRACT FROM AUTHOR]