Search

Steel automotive wheel rims are subject to wear and tear, down to the end of their service life. Manufacturers use standard destructive tests to determine the probable lifetime of the car wheel rim. With this approach, to predict the remaining use time, it is necessary to know the initial parameters of the wheel rim, actual mileage, and its use characteristics, which is difficult information to obtain in the real world. Moreover, this work shows that a vehicle's technical condition can affect the rim's remaining service time. This work describes a new method of precise binary identification of the technical condition of steel car wheel rims using the dispersion of damping factors which result from experimental modal analysis. This work also proposes a new method of indicating the approaching end of wheel rim service life with limited parameters: run-out, average of damping factors, and dispersion of damping factors. The proposed procedure requires two sequential examinations of the rim in standard periods related to the average annual mileage of the vehicle. On this basis, it is possible to indicate the approaching end of the life of the steel rims about 10,000 km in advance. [ABSTRACT FROM AUTHOR]

Diesel fuel stability can be considered from many points of view, of which the two considered most important are stability in contact with the environment and internal stability. Fuel stability in touch with the environment is often defined as oxidation stability, of which measurement procedures are well developed. The presented paper shows that fuel's internal stability can also be important. The internal stability of diesel fuel with the local use of thermal and ultraviolet radiation (UV) as degradation factors and fluorescence signals as a probe is presented in this paper. We show that the internal degradation of fuel with temperature use differs from that with UV and simultaneous both factors use. Our study shows that using temperature as a degradation factor introduces significant fluorescence fading. Moreover, the fluorescence signal restores significantly later than the sample stabilizes at room temperature. The novelty proposed based on examination is hybrid degradation and an examination cycle that enables the simultaneous use of degradation factors and fluorescence reading. For this purpose, a dedicated measurement setup of signal control and processing was constructed and programmed. The measurement procedure of the data series for specific wavelength enables calculation of signal shifts that allow the internal stability classification of diesel fuel samples in less than 30 min with the cost of a single disposable capillary probe and one polymer plug. Premium and regular fuel examination results show that internal fuel stability can be related to polycyclic aromatic hydrocarbons (PAH) concentrations and can be modified with dedicated additives. [ABSTRACT FROM AUTHOR]