Search

In this study, a submerged membrane was installed in a bioreactor to treat N-riched wastewater and obtain high biomass productivity. Chlorella vulgaris was cultivated under mixotrophic, heterotrophic, and photoautotrophic conditions in different kinds of nitrogen sources (nitrate and ammonium) to compare the microalgae growth and nutrient removal in a membrane bioreactor. Further, the respirometric and photosynthetic activities of microalgae were investigated to evaluate the viability of microalgae in different conditions. The highest biomass productivity was obtained under mixotrophic cultivation in ammonium source (0.230 ± 0.009 gr/L d). Moreover, with this type of cultivation and nitrogen source, specific oxygen uptake rate (SOUR) was higher than oxygen product rate (SOPR). However, SOPR improved in mixotrophic cultivation using nitrate source. In both nitrogen source types, the photosynthetic activity of mixotrophic microalgae was reduced at high cell density. Compared favorably with other cultivation types, mixotrophic microalgae could achieve high N and P removal rates (about 23.64–28.84 and 4.38–5.08 mg/L d, respectively). In all cultivation types (except photoautotrophic condition with nitrate source), N and P removal amounts were assimilated to biomass. Based on the obtained results, membrane bioreactor containing mixotrophic microalgae would be the most useful system for application in N-riched wastewater treatment systems. [ABSTRACT FROM AUTHOR]

Abstract: In this study, experiments and computational fluid dynamics were used to evaluate the fouling of membrane surfaces. Based on the resistance-in-series model, the total filtration resistance (R t ) was divided into cake resistance (R c ), adsorption resistance (R a ), internal-plugging (pore-blockage) resistance (R pb ) and intrinsic-membrane resistance (R m ). The values of each resistance and their relative percentages as a function of the operating parameters were experimentally determined. The effect of inlet air-flow rate and the baffle angle on the resistances were also investigated. It was then shown that the permeate flux and resistances could be related to the wall shear stresses of air and liquid flows at the membrane surface. Average shear stress was found to increase by increasing the air-flow rate. The change in baffle angle from 90° to 85° increased the shear stress of air on the membrane surface. At low air-flow rates there was a lower meandering of air as well as the area of the membrane, which is not subject to high-shear increases. The shear stresses of air and liquid on the membrane surface were determined by computational fluid dynamics and correlations were proposed for estimating each resistance of the membrane from these shear stresses. [Copyright &y& Elsevier]