Search

Radar is a non-contact, high-precision vibration measurement device and an important tool for bridge vibration monitoring. Vibration information needs to be extracted from the radar phase, but the radar phase information is sensitive to noise. Under low signal-to-noise ratio (SNR) data acquisition conditions, such as low radar transmission power or a long observation distance, differential phase jump errors occur and clutter estimation becomes difficult, which leads to inaccurate inversion of vibration deformation. Traditional low-pass filtering methods can filter out noise to improve SNR, but they require oversampling. The sampling rate needs to be several times higher than the Doppler bandwidth, which is several times higher than the vibration frequency. This puts high data acquisition requirements on radar systems and causes large data volumes. Therefore, this paper proposes a novel vibration signal filtering method called the periodic filtering method. The method uses the periodicity feature of vibration signals for filtering without oversampling. This paper derives the time-domain and frequency-domain expressions for the periodic filter and presents a deformation inversion process based on them. The process involves extracting the vibration frequency in the Doppler domain, suppressing noise through periodic filtering, estimating clutter using circle fitting on the data complex plane, and inverting final deformation with differential phase. The method is verified through simulation experiments, calibration experiments, and bridge vibration experiments. The results show that the new periodic filtering method can improve the SNR by five times, resolve differential phase jumps, and accurately estimate clutter, thus getting submillimeter-level vibration deformation at low SNR. [ABSTRACT FROM AUTHOR]

The non-stationary clutter of space-based early warning radar (SBEWR) is more serious than that of airborne early warning radar. This phenomenon is primarily attributed to the Earth's rotation and range ambiguity. The increase in clutter degrees of freedom (DOFs) and the significant widening of the clutter suppression notch are not conducive to moving target detection near main lobe clutter. This paper proposes an effective approach to suppress non-stationary clutter based on an interpulse multi-frequency mode for SBEWR. Using the orthogonality of the uniform stepping frequency signal, partial range ambiguity can be effectively suppressed, and the clutter DOFs will be reduced. Subsequently, joint pitch-azimuth-Doppler three-dimensional spacetime adaptive processing and slant range preprocessing are used to perform clutter suppression. This combination not only curtails the estimation error associated with the clutter covariance matrix but also enhances the overall detection capabilities of the system. The simulation results verify the effectiveness of the proposed approach. [ABSTRACT FROM AUTHOR]

This paper deals with the Dual-Function Radar and Communication (DFRC) signal design for a Multiple-Input–Multiple-Output (MIMO) system, considering the presence of signal-dependent clutter. A modulation methodology called Spectral Position Index and Amplitude (SPIA) modulation is proposed, which involves selecting passband and stopband positions and applying amplitude modulation. Signal to Interference plus Noise Ratio (SINR) is maximized to enhance radar detectability. Meanwhile, variable modulus and communication modulation constraints are enforced to ensure compatibility with the current hardware techniques and communication demand, respectively. In addition, the mainlobe width and sidelobe level constraints used to concentrate energy in a specific area of space are enforced. To tackle the resulting nonconvex and NP-hard optimization problem, an Iterative Block Enhancement (IBE) framework that alternately updates each signal in each emitting antenna is exploited to monotonically increase SINR. Each block involves the Dinkelbach's Iterative Procedure (DIP), Sequential Convex Approximation (SCA) and Alternating Direction Method of Multipliers (ADMM) to obtain a single signal. The computational complexity and convergence of the algorithm are analyzed. Finally, the numerical results highlight the effectiveness of the proposed dual-function scheme in sidelobe signal-dependent clutter. [ABSTRACT FROM AUTHOR]

The nonhomogeneous clutter is a major challenge for ship detection in high-frequency mixed-mode surface wave radar. In this paper, a geometric barycenter-based reduced-dimension space-time adaptive processing method is proposed to suppress the clutter. Given the measured dataset, the range correlation of sea clutter is first investigated. Then, joint domain localized processing is applied to solve the training samples starve scenario in a practical system. The geometric barycenter-based training data selector is presented to select valid training samples and improve the accuracy of the clutter covariance matrix estimation. Finally, the validity of the proposed method is verified using the experimental data and the results show that it outperforms the conventional method in the nonhomogeneous environment of a practical system. [ABSTRACT FROM AUTHOR]