Search

Paraffin, due to its linear chain and saturated hydrocarbons with low thermal conductivity, is difficult to transfer energy effectively. Using amphiphilicity of graphene oxide (GO), Pickering emulsion of paraffin@GO was obtained and then paraffin@graphene microencapsulated phase change materials (MEPCMs) were achieved by chemical reduction through adding hydrazine hydrate. Thermally conductive PCMs with segregated structure were constructed by hot compression of paraffin@graphene microencapsules. Scanning electronic microscopy, differential scanning calorimetry and thermal conductivity test were used to characterize microstructure and thermal properties of MEPCMs. Meanwhile, the effect of graphene on the phase change latent heat and phase transition temperature was investigated. Results indicated that GO did not react with paraffin during the process of chemical reduction and the obtained MEPCMs were regular spheres. These MEPCMs had paraffin content of 99% or even more. Graphene working as shell materials increased the phase change latent heat of paraffin from 227.6 to 232.4 J/g, without affecting the phase transition temperature. The hot-compress molding makes graphene shell form segregated structure with more thermal pathways, further enhancing thermal conductivity. The segregated-structure PCMs with high latent heat and thermal conductivity can be applied in energy storage field. [ABSTRACT FROM AUTHOR]

new surface ion-imprinted composite polymer containing 3-methyl-1-phenyl −4-(cis-acylbutenoic acid)-2-pyrazolin-5-one as the functional reagent is presented that is capable of extracting and preconcentrating traces of Th(IV) ion prior to its photometric determination. Parameters affecting the recovery of Th(IV) such as acidity, shaking time, initial concentration of Th(IV), elution condition, sample flow rate, and influence of potentially interfering ions were investigated. The maximum uptake capacity of this material and that of the non-imprinted polymer at pH 4.5 are 56.8 and 26.3 mg g, respectively. Recovery exceeds 95% and is complete within 5 min. A Langmuir isotherm fits the experimental data. The relative selectivity factor for Th(IV)/U(VI), Th(IV)/La(III), and Th(IV)/Ce(III) are 50.8, 78.3, and 82.6, respectively. The relative standard deviation is <2.5%, the detection limit is 0.54 μg L (3σ). The imprinted polymer was coupled to spectrophotometry to separate and determine trace levels of Th(IV) in a soil standard material with satisfactory results. [Figure not available: see fulltext.] [ABSTRACT FROM AUTHOR]