Search

An all-digital sliding-mode (ADSM) controlled dc-dc converter, utilizing single-bit oversampled frequency domain digitizers in its feedback path is proposed. Sliding-mode control provides several benefits over the traditional PID control in terms of fast transient response, robustness to parameter and component variations, and low sensitivity to loop disturbances. However, analog implementations of sliding-mode control require several amplifiers in the controller and suffer from process, voltage, and temperature variations. In the proposed approach, the sliding-mode controller (SMC) is implemented digitally; utilizing a first order single-bit ΣΔ frequency to digital converter (ΣΔFDC)-based feedback and reference digitizing ADCs, running at 32-MHz sampling rate. The ADSM regulator achieves 1% settling time in less than 5 μs for a load variation of 600 mA. The SMC uses a high-bandwidth hysteretic differentiator and an integrator to perform the sliding control law in digital domain. The proposed approach overcomes the steady-state error (or dc offset), and band limits the switching frequency, which are the two common problems associated with SMCs. The IC is designed and fabricated on a 0.35-μm CMOS process occupying an active area of 2.72 mm2. [ABSTRACT FROM AUTHOR]

Efficient current, voltage, and power sensing are critical blocks for power management, switching regulators, maximum power point tracking (MPPT) circuit, and motor control. This paper presents a standard CMOS and low-power current-to-digital converter (IDC) that senses the current flowing at high-voltage nodes. The proposed sensor uses a CMOS-switched capacitor circuit to sense a dc–dc converter output current and gives digital output without an analog-to-digital converter (ADC), or the need for high-voltage technologies. Compared to the resistor-based current-sensing methods that require current-to-voltage circuit, gain block, and an ADC converter, the proposed sensor is a low-power integrated circuit that achieves high resolution, lower complexity, and lower power consumption. The IDC circuit is fabricated on a 5 V, 0.7 μm, and three metal CMOS technology and occupied less than 10% area (1 mm2 area) compared to other sensors. It consumes 18 mW that is less than 40% power consumed by other sensors, and its current measurement error is below 0.4%. The proposed IDC circuit has been characterized as standalone and with a boost dc–dc regulator and MPPT for photovoltaic systems. [ABSTRACT FROM AUTHOR]

A radiation-tolerant digital multiphase current-mode hysteretic point-of-load regulator fabricated on a commercial 180-nm CMOS process is presented. Experiments and simulations are used to demonstrate its single-event immunity and its total-dose tolerance over 100 krad(Si). Key electrical performance parameters are: 5-V input, 0.8–3.3 V output, 10-A load current, 93% peak efficiency, four-phase hysteretic quasi-current-mode buck converter with ±1.5% frequency synchronization, ±3.6% current sharing error, and 1% ripple. [ABSTRACT FROM AUTHOR]