Search

Sn-based high-temperature Pb-free (HTLF) solder pastes have been developed as a drop-in solution to replace high- Pb solder pastes in power discrete applications. The pastes were designed with Indium Corporation's DurafuseVR technology, to combine the merits of two constituent powders. A SnSb-based Ag/ Cu-containing high-temperature powder, with a melting temperature above 320°C, was designed to maintain high-temperature performance. A Sn-rich SnAgCu-Sb powder, with a melting temperature around 228°C, was added to the paste to enhance wetting and improve joint ductility. In the design, the final joint will have the low-melting phase (the melting temperature >228°C) in a controllable quantity embedded into the high-melting SnSb matrix. HTLF-1, one of the designs, maintained the bond shear strength up to 15 MPa, even around 290°C. Another design, HTLF-2, has a similar bond shear strength as Pb92.5/Sn5/Ag2.5 around 290°C, but exceeds substantially below 250°C. The power discrete components had been built with both HTLF solder pastes for both die-attach and clip-bond through the traditional high-Pb process, which demonstrated the drop-in processing compatibility. The components survived three additional surface mounting (SMT) reflows (peak temperature upto 260°C) and passed moisture sensitivity level 1 (MSL1). This confirmed that the maintained joint strength (comparable to or stronger than high-Pb), helped to keep the joint integrity within the encapsulated components in the following SMT process, even with the controlled quantity of the melting phases above 228°C. Both HTLF solder pastes outperformed Pb92.5/Sn5/Ag2.5 in the resistance from drain to source when power is on (RDS(on)), even after 1,000 cycles of temperature cycling test (TCT) under 255/175°C, which is attributed to the intrinsic lower electrical resistivity of Sn in both HTLF pastes. Microstructural observation had shown no corner cracks for both die-attach and clip-bond joints after TCT. [ABSTRACT FROM AUTHOR]