Search

• Carbonate cements and chlorite can alter some pore spaces from water-wet to oil-wet. • High oil saturation occurred in tight reservoirs with moderate carbonates or chlorite. • The high quality reservoirs mainly located in between with sandstone-mudstone interfaces and central parts of the sand bodies. Oil accumulation, being difficult and complicated, is an important issue in petroleum exploration researches. Authigenic minerals, such as carbonate cements and chlorite, can in certain reservoirs alter the wettability of some pore spaces from water-wet to oil-wet. Generally, these oil-wet pore spaces are favorable for oil accumulation. The alteration of reservoir wettability induced by authigenic minerals and the impacts on oil accumulation in tight sandstone reservoirs were investigated using a suite of mineralogical and geochemical characterization techniques, including thin section observation, SEM-EDS, XRD, QEMSEM, CL, quantitative grain fluorescence (QGF), fluorescence spectral analysis, contact angle measurement and sealed coring oil saturation testing on the fourth member of the Lower Cretaceous Quantou Formation (K 1 q 4) in the southern Songliao Basin, China. The study shows that the tight sandstone reservoirs are compositionally immature with detrital grains distributed homogeneously. Quartz, carbonates and clay minerals that show heterogeneous distribution characteristics are the major authigenic minerals in some parts of the intergranular pores. The detrital mineral assemblage suggests that the reservoir rocks at deposition and before diagenesis had characterized by strong water-wet properties. With the development of authigenic minerals, carbonate cements and authigenic chlorite tend to alter the wettability of some parts of the existing pore spaces from water-wet to oil-wet. In the K 1 q 4 sandstone reservoirs, oil prefers to accumulate in the cemented residual pore spaces around carbonate cements and chlorite. Reservoirs containing about 4–5% carbonate cements are suggested to be more preferable to oil accumulation. These reservoirs are mainly located between sandstone-mudstone interfaces and central parts of the sand bodies. Chlorites have mainly two effects: on one hand, chlorite alters the wettability of existing pore spaces and provides preferential accumulation sites for oil in the tight sandstone reservoirs, on the other hand it can reduce the adhesion of oil through forming "clay-oil flocs" and promote further migration. Consequently, the reservoirs with moderate amount of carbonate cements or chlorite always show relative high oil saturation in the K 1 q 4 tight sandstones. [ABSTRACT FROM AUTHOR]

Pore-throat size is a very crucial factor controlling the reservoir quality and oiliness of tight sandstones, which primarily affects rock-properties such as permeability and drainage capillary pressure. However, the wide range of size makes it difficult to understand their distribution characteristics as well as the specific controls on reservoir quality and oiliness. In order to better understand about pore-throat size distribution, petrographic, scanning electron microscopy (SEM), pressure-controlled mercury injection (PMI), rate-controlled mercury injection (RMI), quantitative grain fluorescence (QGF) and environmental scanning electron microscopy (ESEM) investigations under laboratory pressure conditions were performed on a suite of tight reservoir from the fourth member of the Lower Cretaceous Quantou Formation (K 1 q 4 ) in the southern Songliao Basin, China. The sandstones in this study showed different types of pore structures: intergranular pores, dissolution pores, pores within clay aggregates and even some pores related to micro fractures. The pore-throat sizes vary from nano- to micro-scale. The PMI technique views the pore-throat size ranging from 0.001 μm to 63 μm and revealed that the pore-throats with radius larger than 1.0 μm are rare and the pore-throat size distribution curves show evident fluctuations. RMI measurements indicated that the pore size distribution characteristics of the samples with different porosity and permeability values look similar. The throat size and pore throat radius ratio distribution curves had however significant differences. The overall pore-throat size distribution of the K 1 q 4 tight sandstones was obtained with the combination of the PMI and RMI methods. The permeability is mainly contributed by a small part of larger pore-throats (less than 30%) and the ratio of the smaller pore-throats in the samples increases with decreasing permeability. Although smaller pore-throats have negligible contribution on reservoir flow potential, they are very significant for the reservoir storage capacity. The pore-throats with average radius larger than 1.0 μm mainly exist in reservoirs with permeability higher than 0.1mD. When the permeability is lower than 0.1mD, the sandstones are mainly dominated by pore-throats with average radius from 0.1 μm to 1.0 μm. The ratio of different sized pore-throats controls the permeability of the tight sandstone reservoirs in different ways. We suggest that splitting or organizing key parameters defining permeability systematically into different classes or functions can enhance the ability of formulating predictive models about permeability in tight sandstone reservoirs. The PMI combined with QGF analyses indicate that oil emplacement mainly occurred in the pore-throats with radius larger than about 0.25–0.3 μm. This result is supported by the remnant oil micro-occurrence evidence observed by SEM and ESEM. [ABSTRACT FROM AUTHOR]

The Lower Cretaceous Quantou Formation in the southern Songliao Basin is the typical tight oil sandstone in China. For effective exploration, appraisal and production from such a tight oil sandstone, the diagenesis and reservoir quality must be thoroughly studied first. The tight oil sandstone has been examined by a variety of methods, including core and thin section observation, XRD, SEM, CL, fluorescence, electron probing analysis, fluid inclusion and isotope testing and quantitative determination of reservoir properties. The sandstones are mostly lithic arkoses and feldspathic litharenites with fine to medium grain size and moderate to good sorting. The sandstones are dominated by feldspar, quartz, and volcanic rock fragments showing various stages of disintegration. The reservoir properties are quite poor, with low porosity (average 8.54%) and permeability (average 0.493 mD), small pore-throat radius (average 0.206 μm) and high displacement pressure (mostly higher than 1 MPa). The tight sandstone reservoirs have undergone significant diagenetic alterations such as compaction, feldspar dissolution, quartz cementation, carbonate cementation (mainly ferrocalcite and ankerite) and clay mineral alteration. As to the onset time, the oil emplacement was prior to the carbonate cementation but posterior to the quartz cementation and feldspar dissolution. The smectite to illite reaction and pressure solution at stylolites provide a most important silica sources for quartz cementation. Carbonate cements increase towards interbedded mudstones. Mechanical compaction has played a more important role than cementation in destroying the reservoir quality of the K 1 q 4 sandstone reservoirs. Mixed-layer illite/smectite and illite reduced the porosity and permeability significantly, while chlorite preserved the porosity and permeability since it tends to be oil wet so that later carbonate cementation can be inhibited to some extent. It is likely that the oil emplacement occurred later than the tight rock formation (with the porosity close to 10%). However, thicker sandstone bodies (more than 2 m) constitute potential hydrocarbon reservoirs. [ABSTRACT FROM AUTHOR]

The tight sandstones of the Cretaceous Quantou formation are the main exploration target for hydrocarbons in the southern Songliao basin. Authigenic quartz is a significant cementing material in these sandstones, significantly reducing porosity and permeability. For efficient predicting and extrapolating the petrophysical properties within these tight sandstones, the quartz cement and its origin need to be better understood. The tight sandstones have been examined by a variety of methods. The sandstones are mostly lithic arkoses and feldspathic litharenites, compositionally immature with an average framework composition of Q 43 F 26 L 31 , which are characterized by abundant volcanic rock fragments. Mixed-layer illite/smectite (I/S) ordered interstratified with R = 1 and R = 3 is the dominating clay mineral in the studied sandstone reservoirs. Two different types of quartz cementation modes, namely quartz grain overgrowth and pore-filling authigenic quartz, have been identified through petrographic observations, CL and SEM analysis. Homogenization temperatures of the aqueous fluid inclusions indicate that both quartz overgrowths and pore-filling authigenic quartz formed with a continuous process from about 70 °C to 130 °C. Sources for quartz cement produced are the conversion of volcanic fragments, smectite to illite reaction and pressure solution at micro stylolites. Potassium for the illitization of smectite has been sourced from K-feldspar dissolution and albitization. Silica sourced from K-feldspars dissolution and kaolinite to illite conversion is probably only minor amount and volumetrically insignificant. The internal supplied silica precipitate within a closed system where the transport mechanism is diffusion. The quartz cementation can destroy both porosity and permeability, but strengthen the rock framework and increase the rock brittleness effectively at the same time. [ABSTRACT FROM AUTHOR]