Search

In this study, four types of triply periodic minimal surface (TPMS) were implemented to create cellular ceramics via digital light processing (DLP) technology, namely p-cell, gyroid, IWP and s14. The mechanical properties of these TPMS structures were investigated experimentally. Results showed that compressive strength of TPMS structures increases with relative density. IWP and s14 structures exhibit similar mechanical response under stress. In general, all TPMS structures can sustain >2% strain without failure and the compressive strength followed the order of s14 > IWP > gyroid > p-cell. The s14 structure can reach a high compressive strength of 105 MPa at a structural density of 30.5 % while gyroid structure can provide a compressive strength of 5.6 MPa at a very low structural density of 6.7 %. The porosity dependence of Young's modulus of sintered zirconia TPMS demonstrated that the Pabst-Gregorova exponential relation can provide a better prediction than the classical Gibson-Ashby model. [ABSTRACT FROM AUTHOR]

The ceramic honeycomb sandwich structures of 3 mol% yttria-stabilized tetragonal ZrO 2 (3Y-TZP) material were fabricated by an additive manufacturing technique based on the digital light processing (DLP) system. The bending behaviour of hexagonal and square honeycomb sandwich structures was investigated with three-point bending test. The effects of geometric parameters, including the thickness of the face-sheet, the height of the cell, the thickness of the cell wall and the size of the cell, were studied through experiments carefully. The results illustrated that the bending strength of the ceramic honeycomb sandwich structure can reach 170 MPa at a relative density of 41.72%. The geometric parameters of the honeycomb core were more critical than the sandwich face-sheet. The cell size, cell wall thickness and cell height were found to be the preferred geometric parameter for justifying the bending resistance performance of the ceramic sandwich panel. Square honeycomb demonstrated better bending performance than the hexagonal honeycomb. This study provides a new basis for further studies on the ceramic lightweight structures. Image 1 • The honeycomb sandwich structures of ZrO 2 ceramic material were prepared by 3D printing technology. • The effects of four geometric parameters on the bending behavior of honeycomb sandwich structures were studied. • The failure mode had the characteristics of typical brittle fracture of ceramics. • Honeycomb sandwich structure made of ceramic materials had good bending strength and flexural modulus. [ABSTRACT FROM AUTHOR]