Search

This study presents an approach to better characterize the P‐wave and S‐wave velocity structure of the seafloor sediment layer using ocean bottom seismometers. The presence of low‐velocity seafloor sediment layers influences the observed seismic record at the seafloor over a broad frequency range, such that detailed knowledge of this sediment structure is essential to predict its effect on teleseismic records. We use the radial component of teleseismic P waves and autocorrelation functions of the radial, vertical, and pressure components of teleseismic P and S waves to obtain sediment layer models using the Markov chain Monte Carlo approach with parallel tempering. Synthetic tests show that the body waves constrain the P‐ and S‐wave impedances and travel times and the P‐ to S‐wave velocity ratio of the sediment layers. The proposed method resolves thin layers at a high resolution, including the uppermost thin (∼50 m to a few hundred meters) low S‐wave velocity layer. Real data applications at sites across the Pacific Ocean that are coincident with previous in situ studies demonstrate the effectiveness of this method in characterizing the seafloor sediment unit. The sediment models characterized by this new approach will allow us to more accurately predict and correct the effects of sediment layers in generating P‐ and S‐wave reverberations. Plain Language Summary: Ocean bottom seismometers are powerful tools for investigating the detailed structure of the oceanic mantle. However, most ocean bottom seismometers are placed above the low‐velocity water‐saturated sediment layer, such that their seismic records are inevitably affected by this seafloor sediment layer. Detailed constraints on the structure of the seafloor sediment layer allow us to accurately predict its effects on the observed seismic records. The seafloor sediment layer may consist of multiple discontinuities and vary regionally. This study proposes a new approach for characterizing the seismic properties of the seafloor sediment layer using teleseismic body waves recorded at ocean bottom seismometers. Synthetic tests show that the method can resolve thin sublayers within the sediment layer, such as a very thin low shear‐wave velocity layer and sharp seismic velocity jumps. Real data applications show that the sediment models obtained using this approach are in good agreement with those obtained from direct measurements and previous body‐wave analyses. Our proposed method will enable more detailed prediction and correction of the influence of the sediment layer on ocean bottom seismometer records, thereby providing more accurate constraints on deeper Earth structures. Key Points: The seismic properties of the seafloor sediment layer are characterized using ocean bottom seismometer teleseismic body‐wave recordsThe P‐ and S‐wave impedances and travel times and the VP/VS values of each sublayer within the sediment layer are resolvedIn situ seafloor sediment structure constraints will enable accurate correction and prediction of shallow structure effects [ABSTRACT FROM AUTHOR]

This study presents reflectivity images of the northeast (NE) Japan subduction zone continuous across the ocean and land. As nearly half of its forearc region is under the ocean, data from ocean bottom seismometers (OBSs) must be utilized to fully image the region by passive seismic analysis. The use of OBS data has been a challenge due to inherent characters of the ocean bottom observations: high noise level and effects of seafloor sediment. Now, decent imaging is possible in NE Japan overcoming the high level noise due to the accumulated data set of the OBSs. The low‐velocity of seafloor sediment significantly delays and amplifies S waves passing through them, and thus complicates teleseismic waveforms. We identify and correct these effects to produce coherent receiver function images throughout the amphibious subduction zone. Our images provide a potential for discussing new structural features and will help better understanding of the dynamics of the NE Japan subduction zone. Plain Language Summary: In northeast Japan, the Pacific plate is subducting beneath the Japanese arc, and delineating how the actual subduction is taking place at depths has been the target of many seismological studies. This study presents our effort of continuous imaging of subsurface interfaces across the ocean and land employing an amphibious data set. On the land side, there are dense seismic networks that have been used to reveal the seismic interfaces using converted phases of distant earthquakes. On the ocean side, the accumulation of data from temporary ocean bottom seismometers in the last decade and the recently installed ocean bottom cable network has made it possible to use a similar approach as on the land. However, the low‐velocity sediment beneath the seafloor causes systematic slower arrivals and larger amplitudes of the seismic phases of interest that result in highly disturbed images if we analyze them in the same way as the land. Here, we identify and correct the effects of the seafloor sediment to analyze the seismic interfaces across the ocean and land. As a result, we succeed in imaging the interfaces of the subducting oceanic crust throughout the region, as well as previously unidentified features under the ocean that may deserve future investigation. Key Points: The northeast Japan subduction zone is imaged using receiver functions (RFs) of an amphibious data setWe identify significant amplitude and time delay effects on RFs from seafloor sedimentCorrections of the sediment effects significantly improve images across an amphibious region [ABSTRACT FROM AUTHOR]

We analyze seismic records collected at the oldest (170–180 Ma) Pacific seafloor using broadband dispersion array analysis. Using ambient noise and teleseismic waveforms, we measure Rayleigh‐wave phase velocities in a period range of 5–200 s that are inverted for array‐average one‐dimensional isotropic and azimuthally anisotropic shear‐wave velocity depth profiles from the crust to a depth of 300 km. The high‐velocity Lid and the low‐velocity zone are well‐resolved with velocity difference of ∼4%, whose transition occurs at depths between 80 and 100 km. The profile is compared with that obtained at the 130‐ and 140‐Ma seafloor. Accounting for the cooling effect due to the plate age difference, the low‐velocity zone of the oldest Pacific seafloor is ∼1.3% slower (∼110°C warmer) than that beneath the 140‐Ma seafloor, suggesting the occurrence of some reheating process beneath the oldest lithosphere. The azimuthal anisotropy at shallow depths (<50 km) is significantly different between the western and eastern areas of the array where the peak‐to‐peak amplitudes are estimated to be ∼2.8% and ∼1.6%, respectively. The fast direction is nearly parallel to the past seafloor spreading direction (perpendicular to the magnetic lineation) in the west, while it largely deviates in the east. The observed difference in azimuthal anisotropy may represent complicated evolution dynamics of the infant Pacific plate that involved a ridge‐ridge‐ridge triple junction. Plain Language Summary: One of the classical enigmas of plate tectonics is the cause of seafloor flattening where the seafloor depth becomes nearly constant for old ages (>∼70 Ma) while a simple cooling model of plate evolution predicts the age dependence. To solve this enigma, it is essential to resolve the subsurface structure of the oceanic plate and the asthenosphere below. As a part of an international effort, Pacific Array, that aims to cover the Pacific seafloor by arrays of ocean bottom seismometers, a team of Japanese and Korean scientists deployed an array in the oldest (170–180 Ma) Pacific seafloor. We determine isotropic and anisotropic shear‐wave velocity structures as a first step toward resolving the enigma. The results indicate that the asthenosphere beneath the oldest Pacific lithosphere is significantly slower than the prediction of the simple cooling and that the occurrence of some reheating process may be needed. Furthermore, azimuthal anisotropy (the dependence of the wave velocity on the horizontal propagation direction) in the shallow lithosphere shows that the anisotropy patterns differ between the eastern and western areas of the array, and simulation results indicate that the evolution process of the infant Pacific plate is not merely a simple triangular plate spreading. Key Points: Broadband Rayleigh‐wave dispersion array analysis has been conducted in the oldest (∼170 Ma) Pacific seafloorThe low‐velocity zone is significantly slower to indicate the occurrence of some reheating process beneath the oldest Pacific lithosphereThe spatial variation of the shallow azimuthal anisotropy indicates a complicated evolution of the infant Pacific plate [ABSTRACT FROM AUTHOR]