Search

Abstract: A dynamic evaporator model of air source heat pump (ASHP), considering the ratio of the latent heat to sensible heat of wet air, is presented to analyze the performance of ASHP under frosting. The performance parameters, such as the heating capacity, COP and the outlet temperature of compressor, are simulated with CYCLEPAD. Then a semi-empirical correlation that predicts frost accumulation on the air-side of fin-tube heat exchanger is developed with dimensionless analysis and also modified by a test conducted under cold-moist conditions in winter. In addition, eight influence factors are considered involving the ambient conditions and structures of heat exchanger, whose effects are analyzed as well. Among them, the equivalent diameter of air flow cross-section in fin-tube deq is especially proposed. Lastly, the relationships between the ratio, the performance parameters and the frost accumulation are discussed in this paper, followed by an evaluation of an optimal defrosting time interval to improve the ASHP’s energy efficiency and operational reliability at cold-moist conditions in central-south China. [Copyright &y& Elsevier]

Abstract: The use of groundwater for cooling and heating purposes is of interest from both the economical and the ecological perspective. The groundwater heat pump (GWHP) system utilizes groundwater as alternative renewable and clean energy source for space heating and/or cooling, withdraws water from a production well, passes it through a heat exchanger and discharges the water into an injection well. By utilizing the relatively stable temperature of groundwater, GWHP system can achieve a higher coefficient of performance. Due to the utilization of groundwater stored in the aquifer, the assessment of the hydraulic capacity of the aquifer based on numerical groundwater models is always needed for the optimum design and the efficient performance of GWHP. In this paper, numerical methods of underground heat-water transfer, energy balance method and thermal storage method were presented to calculate the capacity of unit area of shallow groundwater aquifer. The model results indicate that the numerical method, which is based on performance efficiency of GWHP, represents the behaviour of groundwater pumping/recharging processes, and serves better than energy balance method and thermal storage method, in addition it has been proven itself that this method has the advantages of energy saving and environmental protection. The calculated capacity is positively related to aquifer thickness. It is found that it is easy for ground water recharge in alluvial and pluvial fan located at the piedmont, while the calculated capacity is relatively smaller compared with that of south-east plain where it is not easy for groundwater recharge. [Copyright &y& Elsevier]