Search

This paper proposes a new inverter topology based on the active neutral-point-clamped (ANPC) converter with capability to integrate one energy storage system (ESS) per inverter leg with an independent state of charge control, so that each inverter leg has two dc ports and one ac port. The primary dc port is common to all inverter legs and it is connected to the main power source. The secondary dc port is suitable for ESS connection because of its two-quadrant operation, with bidirectional current capability, so that the ESS can be charged and discharged with regulated current. Integration of a secondary dc port with independent control also allows the use of different ESS technologies for each inverter leg to compose a hybrid ESS. Redundant switching states of the proposed structure are used to balance the energy exchanged between the secondary dc port and the dc bus capacitors. Theoretical propositions were experimentally validated through a 1-kW single-phase inverter with a secondary dc port connected to a 230-V ESS and ac port connected to an LC filter feeding a linear load. Low total harmonic distortion (THD) sinusoidal current is generated at the ac port while charging or discharging the ESS with a constant current. [ABSTRACT FROM AUTHOR]

This paper proposes a control system for the single-phase Three-Ports Active Neutral- Point-Clamped (ANPC-3P) converter, which can inject a sinusoidal current into the grid, balance the neutral point voltage, and regulate the energy storage system (ESS) current with reduced low-frequency ripple. Despite other applications, ANPC-3P inverter can be used in grid-tied renewable generation to allow the simultaneous connection of a photovoltaic (PV) energy source and an ESS to the AC grid. The ESS is connected directly to the inverter circuit without any auxiliary DC-DC converter, but due to the DC bus pulsed power, it can be subjected to low-frequency current ripple. This undesired current ripple is difficult to filter and can lead to shorter battery life. A control system based on well-known controllers is analyzed and designed. Theoretical analysis is validated experimentally using a single-phase 1-kW prototype. [ABSTRACT FROM AUTHOR]

• Voltage regulation using combined active and reactive power. • Control algorithm for active energy minimization in voltage regulation. • A comparative analysis performed on a battery energy storage system. The voltage drop affecting consumers at the end of distribution lines is one of the problems regarding power quality. The solutions applied to transmission lines are not fully effective in distribution lines, where line parameters are significantly high. In low-voltage distribution network, the reactive power compensation method is not as effective as active and reactive power compensation. This effect occurs on lines where the significant series resistance becomes remarkable in relation to the total line impedance. This paper presents the design and implementation of a four-wire, three-phase voltage source converter (VSC) with output current control for voltage regulation at the point of common coupling (PCC), using active and reactive power injection. A reactive power prioritization and minimization of active power strategy is proposed to overcome the problem of distribution line parameters. Digital design methodology is used to design the management controllers and loops, and a digital signal controller (DSC) is used for the entire implementation. The mathematical analysis results are validated using numerical simulation and proven with the construction of a 3.8 kVA prototype. The results showed that the converter accomplished an effective voltage regulation at the PCC with reduced active power. [ABSTRACT FROM AUTHOR]