Search

In this paper, the structure, coordinate control method, and parameter design of a hybrid system are proposed for active power injection and nonactive power (reactive, harmonic, and unbalance power) compensation. The proposed hybrid system consists of a static var compensator (SVC) in parallel with a capacitive-coupling grid-connected inverter (CGCI) (SVC//CGCI). In SVC//CGCI, the SVC part is used to dynamic compensate the reactive power and unbalance power, while the low rating CGCI part is used to inject active power, provide harmonic power and a fixed amount of capacitive reactive power. Compared with conventional inductive-coupling grid-connected inverter (IGCI), the CGCI can provide active, reactive and harmonic power with low rating of active inverter part. The cost of the SVC part is much lower than that of active inverter part, thus the reduction of inverter rating can lead to a decrease in the total cost of the SVC//CGCI. Therefore, the SVC//CGCI can be a cost effective solution for active power injection and nonactive power compensation. Finally, simulation and experimental results are provided to show the advantages and validity of the proposed SVC//CGCI in compared with the conventional IGCI and SVC//IGCI. [ABSTRACT FROM AUTHOR]

In this study, a minimizing inverter capacity design is proposed, and the characteristics and performance of static VAR compensator (SVC) coupling hybrid active power filters (SVC-HAPFs) are analyzed. The cost of the SVC part is much lower than that of the active inverter part, and thus, the reduction of inverter part capacity can lead to a decrease in the total cost of SVC-HAPF. To demonstrate the advantages of the proposed minimizing inverter capacity design of SVC-HAPF, comparisons are given between the conventional and the proposed SVC-HAPF designs. Comparisons are also provided among active power filters (APFs), HAPFs, and the proposed SVC-HAPF in terms of dc-link voltage, compensation range, and performance. Finally, simulation and laboratory-scale experimental results are given to validate the minimizing inverter capacity design, and to verify the characteristics and compensation performances of APF, HAPF, and the proposed SVC-HAPF. [ABSTRACT FROM AUTHOR]

This paper proposes a new type dc/ac inverter named: hybrid-coupling grid-connected inverter (HGCI) for photovoltaic active power generation with power quality conditioning, which consists of a full-bridge three-phase dc/ac inverter coupling to the power grid in series with a thyristor-controlled LC filter. Compared with the conventional inductive-coupling grid-connected inverter (IGCI) and capacitive-coupling grid-connected inverter (CGCI), the proposed HGCI has distinct characteristics of wide operational range and low dc-link operating voltage. Based on these prominent characteristics, the system cost and operational cost can be reduced. Moreover, it can transfer the active power and compensate reactive power, unbalanced power, and harmonic power simultaneously. In this paper, the analysis of the structure, parameter design, and control method of the HGCI is proposed and presented. Finally, simulation and experimental results are provided to verify the effectiveness and performance of the proposed HGCI in comparison with the IGCI and CGCI. [ABSTRACT FROM AUTHOR]

When the load generated harmonic, unbalanced, and reactive power is beyond the limited capacity of a thyristor-controlled LC-coupling hybrid active power filter (TCLC-HAPF), the TCLC-HAPF with the conventional control methods cannot provide satisfactory compensation performance. In this paper, a selective compensation control method of harmonic distortion, unbalanced and reactive power of the TCLC-HAPF is proposed, which can function even at different voltage conditions (e.g., voltage dip, voltage fault, etc.). First, the proposed control method decomposes the load power into fundamental positive-sequence reactive power, fundamental negative-sequence power (unbalanced power), and harmonic power. Then, the decomposed reactive, unbalanced, and harmonic power can be selectively or fully compensated based on the capacity of the TCLC-HAPF. Finally, simulation and experimental results are provided to verify the effectiveness of the proposed selective compensation control method for the TCLC-HAPF. [ABSTRACT FROM PUBLISHER]

In this paper, a new modeling and parameter design method for the thyristor-controlled LC-coupled hybrid active power filter (TCLC-HAPF) is proposed, which includes the analysis of the inner flowed three-phase unbalanced power during unbalanced condition. Different from the conventional method which ignores the inner flowed three-phase unbalanced power, the proposed design method can achieve better performance during unbalanced compensation. To verify the validity and advantages of the proposed modeling and parameter design method of TCLC-HAPF, the mathematical analysis, representative simulation and experimental results for compensating different unbalanced loading situation are presented in comparison with the conventional design method. [ABSTRACT FROM PUBLISHER]

This paper proposes a control strategy for a three-phase three-wire thyristor-controlled LC -coupling hybrid active power filter (TCLC-HAPF), which can balance active power and compensate reactive power and harmonic currents under unbalanced loading. Compared with TCLC-HAPF with conventional control strategy, active power filters and hybrid active power filters which either fail to perform satisfactory compensation or require high-rating active inverter part for unbalanced compensation, a control strategy was proposed for TCLC-HAPF to operate with a small rating active inverter part for a variety of loads with satisfactory performance. The control idea is to provide different firing angles for each phase of the thyristor-controlled LC-coupling part (TCLC) to balance active power and compensate reactive power, while the active inverter part aims to compensate harmonic currents. First, the required different TCLC impedances are deduced. Then, independent firing angles referenced to the phase angle of voltage across TCLC are calculated. After angle transformations, final firing angles referenced to phase angle of load voltages are obtained. In this paper, a novel controller for TCLC-HAPF under unbalanced loading is proposed. Simulation and experimental results are provided to verify the effectiveness of the proposed controller in comparison with a state-of-the-art controller. [ABSTRACT FROM PUBLISHER]

This paper proposes a hybrid static synchronous compensator (hybrid-STATCOM) in a three-phase power transmission system that has a wide compensation range and low dc-link voltage. Because of these prominent characteristics, the system costs can be greatly reduced. In this paper, the circuit configuration of hybrid-STATCOM is introduced first. Its V–I characteristic is then analyzed, discussed, and compared with traditional STATCOM and capacitive-coupled STATCOM (C-STATCOM). The system parameter design is then proposed on the basis of consideration of the reactive power compensation range and avoidance of the potential resonance problem. After that, a control strategy for hybrid-STATCOM is proposed to allow operation under different voltage and current conditions, such as unbalanced current, voltage dip, and voltage fault. Finally, simulation and experimental results are provided to verify the wide compensation range and low dc-link voltage characteristics and the good dynamic performance of the proposed hybrid-STATCOM. [ABSTRACT FROM PUBLISHER]

In this paper, the structure, modeling, parameter design, and control method are proposed for a new hybrid structure of a static var compensator in parallel with a hybrid active power filter (SVC//HAPF). The SVC part of the SVC//HAPF is used to dynamically compensate the reactive power. And, the HAPF part is used to provide harmonic power and small amount of reactive power compensation. Due to the large fundamental voltage drop on coupling the LC part, the active inverter part of the SVC//HAPF has low voltage rating. Meanwhile, the parallel-connected SVC acts as a current divider to reduce the active inverter current. Therefore, the proposed SVC//HAPF shows the great promise in compensating harmonic current and wide-range reactive power with a low (both) voltage and current rating active inverter part. To show the advantages of the proposed SVC//HAPF, simulation comparisons among the active power filter (APF), HAPF, SVC in series with HAPF (SVC−HAPF), and the proposed SVC//HAPF are provided. Finally, experimental results based on the laboratory-scaled hardware prototype are given to show the validity of the SVC//HAPF. [ABSTRACT FROM PUBLISHER]

The intelligent substations should be developed to perform multifunction operations, including power flow control, voltage regulation, and cost-effective power quality (PQ) improvement. In this article, an intelligent substation by a distribution transformer integrated with a capacitive-coupling winding tap injection static synchronous compensator (CWTI-DSTATCOM) is proposed for balance and unbalance operations. Compared with the state-of-the-art approaches, CWTI-DSTATCOM can operate at a low dc voltage with a small active inverter rating, which also can provide distributed voltage, reactive, and unbalanced current compensation. The power rating reduction mechanism is mathematically revealed via balance and unbalance compensation analysis, which is further used to determine the optimal inverter power rating of unbalance operation via an optimal LC filter design method. Furthermore, a comprehensive compensation control strategy is developed to coordinate the transformer taps and the active inverter under balanced and unbalanced operations. Simulation and real-time digital simulator hardware-in-the-loop experiments are performed to prove the validity and effectiveness of the proposed topology over inverter rating reduction and PQ enhancement. [ABSTRACT FROM AUTHOR]

The capacitive-coupling grid-connected inverter (CGCI) is coupled to the point of common coupling via a second-order LC branch. Its operational voltage is much lower than that of a conventional inductive-coupling grid-connected inverter (IGCI) when it serves as a multifunctional inverter to compensate reactive power and transfer active power simultaneously. It is a promising solution for microgrid and building-integrated distributed generator systems. A quasi-proportional-resonant (quasi-PR) controller is applied to reduce the steady-state current tracking errors of the CGCI in this paper. The quasi-PR controller generates the voltage reference for use of carrier-based pulse-width modulation, which can effectively reduce output current ripples. The second-order coupling impedance of the CGCI causes its modeling and controller design to differ from that of the conventional IGCI. A comprehensive design method for the quasi-PR controller in a CGCI is developed. The quasi-PR controller is also compared with a proportional-integration current controller. Simulation results are provided to verify the effectiveness of the quasi-PR controller and its design method in a CGCI. The current tracking errors are greatly reduced when the quasi-PR controller rather than the proportional-integration controller is applied. Experimental results are also provided to validate the CGCI as a multifunctional grid-connected inverter. [ABSTRACT FROM PUBLISHER]

Previous researches on space vector modulation (SVM) in active power filters (APFs) topologies find that compared with sinusoidal pulse width modulation, the SVM offers a better harmonic spectrum and has 15.47% more voltage utilization. The article not only proposes SVM for hybrid active power filters (HAPFs) but also answers the following questions. 1) Under what conditions both filters are equivalent to one another? 2) Which filter can enhance better tracking ability and better performance? 3) How the coupling component parameters and dc voltage affect the performance of both filters? The representative simulation and experimental results are given to verify the discussions. The conclusions can be application guidelines for the design of inductive and capacitive coupling inverters (e.g., APFs and HAPFs) in smart grids and development of energy internet due to their generalities to applications. [ABSTRACT FROM AUTHOR]