Search

This work investigates the effect of alternating current partial discharge (AC PD) byproducts on the dielectric frequency response (DFR) of oil-paper insulation comprising of a small cavity, in the frequency range of 1.0 mHz to 1.0 kHz. The investigations were done by utilizing experimental results in combination with a Finite Element Method (FEM) model. The results presented in this paper show that ageing by-products in the cavity (PD stressed volume) alone will not result into the change in DFR of oil-paper insulation. According to simulation results, the significant change in the DFR results is mainly caused by PD by-products (positive and negative charges, and electrons) which tend to conduct or diffuse into the bulk of oil-paper insulation. The change in a dissipation factor curve due to PD by-products was observed to occur mainly in the middle and low frequency regions. The results indicate that the dissipation factor curves in the middle and low frequency regions depend on the level of PD by-products in oil and paper, respectively. [ABSTRACT FROM AUTHOR]

In this paper, the influence of partial discharges (PD) on the subsequent dielectric properties of oil-impregnated paper (OIP) is investigated. Dielectric frequency response (DFR) of OIP is investigated at varied levels of moisture, thermal aging, temperature, oil conductivity and electrode material, to allow comparison of these influences. It is shown that PD activity inside OIP can significantly change the real and imaginary parts of permittivity of the paper layers, especially in the frequency range below 100 Hz. It is shown that even if the PD activity is concentrated on a few percent of the test sample, the real part of permittivity measured on the entire sample after a few tens of hours of PD activity can increase up to 10 times at very low frequencies (∼ 1 mHz) and the imaginary part of the permittivity can increase up to 100 times at low frequencies (∼ 1 Hz). The change of the real and imaginary parts of permittivity due to PD activity is permanent. It is very similar to the change caused by thermal aging, and somewhat similar to the change caused by moisture and higher oil conductivity. It is also shown that the dissipation factor of OIP in contact with copper and brass increases, even in the absence of PD, but contact with aluminum and stainless steel has no influence on DFR of OIP. The results suggest that the influence of PD can be significant when estimating the moisture content or the level of thermal aging of OIP with DFR method. [ABSTRACT FROM PUBLISHER]