Search

During the summer of 2018, the upward-pointing Wyoming Cloud Lidar (WCL) was deployed on board the University of Wyoming King Air (UWKA) research aircraft for the Biomass Burning Flux Measurements of Trace Gases and Aerosols (BB-FLUX) field campaign. This paper describes the generation of calibrated attenuated backscatter coefficients and aerosol extinction coefficients from the WCL measurements. The retrieved aerosol extinction coefficients at the flight level strongly correlate (correlation coefficient, rr > 0.8) with in situ aerosol concentration and carbon monoxide (CO) concentration, providing a first-order estimate for converting WCL extinction coefficients into vertically resolved CO and aerosol concentration within wildfire smoke plumes. The integrated CO column concentrations from the WCL data in nonextinguished profiles also correlate (rr = 0.7) with column measurements by the University of Colorado Airborne Solar Occultation Flux instrument, indicating the validity of WCL-derived extinction coefficients. During BB-FLUX, the UWKA sampled smoke plumes from more than 20 wildfires during 35 flights over the western United States. Seventy percent of flight time was spent below 3 km above ground level (AGL) altitude, although the UWKA ascended up to 6 km AGL to sample the top of some deep smoke plumes. The upward-pointing WCL observed a nearly equal amount of thin and dense smoke below 2 km and above 5 km due to the flight purpose of targeted fresh fire smoke. Between 2 and 5 km, where most of the wildfire smoke resided, the WCL observed slightly more thin smoke than dense smoke due to smoke spreading. Extinction coefficients in dense smoke were 2–10 times stronger, and dense smoke tended to have larger depolarization ratio, associated with irregular aerosol particles. [ABSTRACT FROM AUTHOR]

The National Oceanic and Atmospheric Administration (NOAA) Geostationary Operational Environmental Satellite series R (GOES-R) will greatly expand the ability to observe the earth from geostationary orbit compared to the current-generation GOES, with more than 3 times as many spectral bands and a 75% reduction in footprint size. These enhanced capabilities are beneficial to rainfall rate estimation since they provide sensitivity to cloud-top properties such as phase and particle size that cannot be achieved using the limited channel selection of current GOES. The GOES-R rainfall rate algorithm, which is an infrared-based algorithm calibrated in real time against passive microwave rain rates, has been previously described in an algorithm theoretical basis document (ATBD); this paper describes modifications since the release of the ATBD, including a correction for evaporation of precipitation in dry regions and improved calibration updates. These improvements have been evaluated using a simplified version applicable to current-generation GOES to take advantage of the high-resolution ground validation data routinely available over the conterminous United States. Correcting for subcloud evaporation using relative humidity from a numerical model reduced false alarm rainfall by half and reduced the overall error by 35% for hourly accumulations validated against the National Centers for Environmental Prediction stage IV radar-gauge field; however, the number of missed events did increase slightly. Reducing the size of the calibration regions and increasing the training data requirements improved the consistency of the retrieved rates in time and space and reduced the overall error by an additional 4%. [ABSTRACT FROM AUTHOR]