Search

We present the measurement of cloud base height (CBH) derived from the Doppler Lidar (DL), Ceilometer (CM) and Moderate Resolution Imaging Spectroradiometer (MODIS) satellite over a high altitude station in the central Himalayan region for the first time. We analyzed six cases of cloud overpass during the daytime convection period by using the cloud images captured by total sky imager. The occurrence of thick clouds (> 50%) over the site is more frequent than thin clouds (< 40%). In every case, the CBH indicates less than 1.2 km, above ground level (AGL) observed by both DL and CM instruments. The presence of low level clouds in the height-time variation of signal to noise ratio of DL and backscatter of CM shows a similar diurnal pattern on all days. Cloud fraction is found to be maximum during the convective period. The CBH estimated by the DL and CM showed reasonably good correlation (R² = 0.76). The DL observed updraft fraction and cloud base vertical velocity also shows good correlation (R² = 0.66). The inter-comparison between DL and CM will have implications in filling the gap of CBH measurements by the DL, in absence of CM. More deployments of such instruments will be invaluable for the validations of meteorological models over the observationally sparse Indian regions. [ABSTRACT FROM AUTHOR]

The potential impact of climate change on agriculture is uncertain. In addition, agriculture could influence above-and below-ground carbon storage. Development of models that represent agriculture is necessary to address these impacts. We have developed an approach to integrate agriculture representations for three crop types - maize, soybean, and spring wheat - into the coupled carbon-nitrogen version of the Community Land Model (CLM), to help address these questions. Here we present the new model, CLMCrop, validated against observations from two AmeriFlux sites in the United States, planted with maize and soybean. Seasonal carbon fluxes compared well with field measurements for soybean, but not as well for maize. CLM-Crop yields were comparable with observations in countries such as the United States, Argentina, and China, although the generality of the crop model and its lack of technology and irrigation made direct comparison difficult. CLM-Crop was compared against the standard CLM3.5, which simulates crops as grass. The comparison showed improvement in gross primary productivity in regions where crops are the dominant vegetation cover. Crop yields and productivity were negatively correlated with temperature and positively correlated with precipitation, in agreement with other modeling studies. In case studies with the new crop model looking at impacts of residue management and planting date on crop yield, we found that increased residue returned to the litter pool increased crop yield, while reduced residue returns resulted in yield decreases. Using climate controls to signal planting date caused different responses in different crops. Maize and soybean had opposite reactions: when low temperature threshold resulted in early planting, maize responded with a loss of yield, but soybean yields increased. Our improvements in CLM demonstrate a new capability in the model - simulating agriculture in a realistic way, complete with fertilizer and residue management practices. Results are encouraging, with improved representation of human influences on the land surface and the potentially resulting climate impacts. [ABSTRACT FROM AUTHOR]

The article presents information on a study conducted on the impact of climate change on agriculture. In the study, Community Land Model (CLM)-Crop was validated against observations from two agricultural sites in the U.S., that were planted with maize and soybean. CLM-Crop was compared with the standard CLM3.5, which is associated with crops as grass. The study found that crop yields and productivity had a negative correlation with temperature, and a positive correlation with precipitation.