Search

Abstract: The use of groundwater for cooling and heating purposes is of interest from both the economical and the ecological perspective. The groundwater heat pump (GWHP) system utilizes groundwater as alternative renewable and clean energy source for space heating and/or cooling, withdraws water from a production well, passes it through a heat exchanger and discharges the water into an injection well. By utilizing the relatively stable temperature of groundwater, GWHP system can achieve a higher coefficient of performance. Due to the utilization of groundwater stored in the aquifer, the assessment of the hydraulic capacity of the aquifer based on numerical groundwater models is always needed for the optimum design and the efficient performance of GWHP. In this paper, numerical methods of underground heat-water transfer, energy balance method and thermal storage method were presented to calculate the capacity of unit area of shallow groundwater aquifer. The model results indicate that the numerical method, which is based on performance efficiency of GWHP, represents the behaviour of groundwater pumping/recharging processes, and serves better than energy balance method and thermal storage method, in addition it has been proven itself that this method has the advantages of energy saving and environmental protection. The calculated capacity is positively related to aquifer thickness. It is found that it is easy for ground water recharge in alluvial and pluvial fan located at the piedmont, while the calculated capacity is relatively smaller compared with that of south-east plain where it is not easy for groundwater recharge. [Copyright &y& Elsevier]

Abstract: Lightweight envelopes are widely used in modern buildings but they lack sufficient thermal capacity for passive solar utilization. An attractive solution to increase the building thermal capacity is to incorporate phase change material (PCM) into the building envelope. In this paper, a simplified theoretical model is established to optimize an interior PCM for energy storage in a lightweight passive solar room. Analytical equations are presented to calculate the optimal phase change temperature and the total amount of latent heat capacity and to estimate the benefit of the interior PCM for energy storage. Further, as an example, the analytical optimization is applied to the interior PCM panels in a direct-gain room with realistic outdoor climatic conditions of Beijing. The analytical results agree well with the numerical results. The analytical results show that: (1) the optimal phase change temperature depends on the average indoor air temperature and the radiation absorbed by the PCM panels; (2) the interior PCM has little effect on average indoor air temperature; and (3) the amplitude of the indoor air temperature fluctuation depends on the product of surface heat transfer coefficient h in and area A of the PCM panels in a lightweight passive solar room. [Copyright &y& Elsevier]