Search

Summary: The continuous increase of the distributed energy resources (DERs) penetration levels leads to voltage stability problems in the distribution system. One of the approaches for the mentioned emerging challenge is the proper placement of automatic voltage regulators (AVRs). This paper investigates the optimal placement and sizing of AVRs in a distribution network by presenting a new modification of the teaching‐learning‐based optimization (TLBO) algorithm. The objective functions consist of minimizing the distribution system voltage deviation, energy generation cost, and electrical losses. The modification improves the convergence velocity and accuracy of the TLBO algorithm using the combination of mutation technique and quasi‐opposition‐based‐learning concept. This paper compares the performance of the proposed algorithm with other famous evolutionary algorithms. The test distribution system contains installed DERs that work more efficiently after the placement of AVRs based on the mentioned objective functions by the proposed optimization algorithm. The simulation results display the best optimization algorithms for AVRs placement with a significant level of less than 0.10 (ie, probability‐value). The proposed multiobjective optimization algorithm's considerable merit is the accuracy and convergence velocity in solving this specific optimization problem. [ABSTRACT FROM AUTHOR]

Summary: This paper proposes a two‐stage planning approach for the efficient utilization of distributed generation (DG) and capacitor banks (CBs) for the simultaneous grid‐connected and islanded operations of the balanced distribution networks. The first stage determines the optimal installation locations and capacities of DGs and CBs using an improved variant of the Jaya optimization algorithm (IJaya) to minimize the power losses and voltage deviation during the grid‐connected operation of the distribution network. The second stage identifies the optimal operating point of the DG and CB combination to carry the maximum load during the islanded network operation under power supply‐demand imbalance conditions. For the second stage, an analytical approach is proposed to identify the best operating power factor for the DG‐CB combination, calculating the power loss, and under‐utilization of the installed real‐reactive power sources. Simulation results on the IEEE 33‐bus grid‐dependent distribution network demonstrate that the proposed IJaya significantly improved the network performance and outperforms various existing optimization methods. In addition, during the network's islanded operation, maintaining the network power factor equal to the source power factor (pfsource) makes the DG‐CB combination operate at their rated capacities. [ABSTRACT FROM AUTHOR]