Search

This paper deals with a new family of high boost voltage inverters called switched-inductor quasi-Z-source inverters (SL-qZSIs). The proposed SL-qZSI is based on the well-known qZSI topology and adds only one inductor and three diodes. In comparison to the SL-ZSI, for the same input and output voltages, the proposed SL-qZSI provides continuous input current, a common ground with the dc source, reduced the passive component count, reduced voltage stress on capacitors, lower shoot-through current, and lower current stress on inductors and diodes. In addition, the proposed SL-qZSI can suppress inrush current at startup, which might destroy the devices. This paper presents the operating principles, analysis, and simulation results, and compares them with those of the SL-ZSI. To verify the performance of the proposed converter, a laboratory prototype was constructed with 48 Vdc input and an ac output line-to-line voltage of 120 Vrms. The simulation and experimental results verified that the converter has high step-up inversion ability. [ABSTRACT FROM AUTHOR]

In this paper, three dc/dc ladder multilevel converters are compared. The first one is the classical ladder topology and the two other topologies presented are based on the classical one. A mathematical calculation of the output resistance and the gain of the converter as a function of the number of levels is carried out for the three topologies in order to estimate the voltage drop due to the output current. These calculations are validated with simulations and experimental results. Finally, the behavior of the three topologies is compared through experimental tests. Results show higher performance for the presented converters compared to the classical ladder. [ABSTRACT FROM AUTHOR]

Compared with neutral-point-clamped (NPC) inverters, active NPC (ANPC) inverters enable a substantially increased output power and an improved performance at zero speed for high-power electrical drives. This paper analyzes the operation of three-level (3L) ANPC inverters under device failure conditions, and proposes the fault-tolerant strategies to enable continuous operating of the inverters and drive systems under single and multiple device open- and short-failure conditions. Therefore, the reliability and robustness of the electrical drives are greatly improved. Moreover, the proposed solution adds no additional components to standard 3L-ANPC inverters; thus, the cost for robust operation of drives is lower. Simulation and experiment results are provided for verification. Furthermore, a comprehensive comparison for the reliability function of 3L-ANPC and 3L-NPC inverters is presented. The results show that 3L-ANPC inverters have higher reliability than 3L-NPC inverters when a derating is allowed for the drive system under fault-tolerant operation. If a derated operation is not allowed, the two inverters have similar reliability for device open failure, while 3L-NPC inverters have higher reliability than 3L-ANPC inverters for device short failure. [ABSTRACT FROM AUTHOR]

In this paper, a new topology of a cascaded multilevel converter is proposed. The proposed topology is based on a cascaded connection of single-phase submultilevel converter units and full-bridge converters. Compared to the conventional multilevel converter, the number of dc voltage sources, switches, installation area, and converter cost is significantly reduced as the number of voltage steps increases. In order to calculate the magnitudes of the required dc voltage sources, three methods are proposed. Then, the structure of the proposed topology is optimized in order to utilize a minimum number of switches and dc voltage sources, and produce a high number of output voltage steps. The operation and performance of the proposed multilevel converter is verified by simulation results and compared with experimental results of a single-phase 49-level converter, too. [ABSTRACT FROM AUTHOR]