Search

The west coast and islands of Taiwan have abundant wind resource, which offers a great opportunity for large-scale offshore wind power generation. In Taiwan, the first stage of the offshore wind farms at the Jhang-Bin and Penghu areas has been planned. In particular, the Jhang-Bin wind farm will become the first and one of the largest wind farms in Taiwan. Therefore, its impacts on system operation and security have to be investigated and studied in advance. Following a general connection design discussion, this paper is consist of four major system impact analyses: load flow, fault current, voltage variation, and transient stability. Moreover, three types of typical wind turbines have been adopted in this paper in order to compare their performances on the wind farm integration system. From the simulation results, some significant conclusion and recommendations have been extracted, which would contribute to the first offshore wind farm development in Taiwan. [ABSTRACT FROM AUTHOR]

Compared with neutral-point-clamped (NPC) inverters, active NPC (ANPC) inverters enable a substantially increased output power and an improved performance at zero speed for high-power electrical drives. This paper analyzes the operation of three-level (3L) ANPC inverters under device failure conditions, and proposes the fault-tolerant strategies to enable continuous operating of the inverters and drive systems under single and multiple device open- and short-failure conditions. Therefore, the reliability and robustness of the electrical drives are greatly improved. Moreover, the proposed solution adds no additional components to standard 3L-ANPC inverters; thus, the cost for robust operation of drives is lower. Simulation and experiment results are provided for verification. Furthermore, a comprehensive comparison for the reliability function of 3L-ANPC and 3L-NPC inverters is presented. The results show that 3L-ANPC inverters have higher reliability than 3L-NPC inverters when a derating is allowed for the drive system under fault-tolerant operation. If a derated operation is not allowed, the two inverters have similar reliability for device open failure, while 3L-NPC inverters have higher reliability than 3L-ANPC inverters for device short failure. [ABSTRACT FROM AUTHOR]

This paper describes three data driven methods to monitor electromechanical oscillations in interconnected power system operation. The objective is to compare and contrast the performance of the methods. The accuracy of damping ratio and frequency of oscillations are the measures of the performance of the algorithms. The advantages and disadvantages of various techniques and their limitations to measurement noise have been considered while assessing performance. The target frequency and damping are computed using the Nordic power system simulation model. [ABSTRACT FROM PUBLISHER]

The growing importance of signal integrity (SI) analysis in integrated circuits (ICs), revealed by modern system-in-package methods, is demanding for new models for the IC sub-systems which are both accurate, efficient and extractable by simple measurement procedures. This paper presents the contribution for the establishment of an integrated IC modeling approach whose performance is assessed by direct comparison with the signals measured in laboratory of two distinct memory IC devices. Based on the identification of the main blocks of a typical IC device, the modeling approach consists of a network of system-level sub-models, some of which with already demonstrated accuracy, which simulated the IC interfacing behavior. Emphasis is given to the procedures that were developed to validate by means of laboratory measurements (and not by comparison with circuit-level simulations) the model performance, which is a novel and important aspect that should be considered in the design of IC models that are useful for SI analysis. [ABSTRACT FROM PUBLISHER]