Search

The snubber circuit is a cost-effective solution to reduce the severe turn-off overvoltage and oscillation caused by the fast switching characteristics of SiC MOSFET. However, the turn-on switching losses will significantly increase as the snubber decouples the power loop parasitic inductance during the switching process. In this article, the effect of the power loop parasitic inductance on the switch performance of SiC MOSFETs and the quasi-zero voltage switching (QZVS) turn-on condition are studied. On this basis, an SiC MOSFET overvoltage and oscillation suppression circuit (OVSC) with not only the switching losses optimization feature but also the clamping energy feedback characteristic is proposed. The overvoltage and oscillation can be effectively suppressed by clamping capacitors, and those capacitors do not participate in the switching process until the overvoltage occurs, which is of benefit to the switching losses reduction compared with the other normal snubber circuits. Besides, the turn-off overvoltage and oscillation energy stored in the clamping capacitors can be feedback to dc and load side through a passive branch composed of an energy feedback inductor and a diode. The experimental studies and comprehensive comparison studies are carried out to verify the validity of the proposed OVSC. The experimental results show that OVSC has excellent overvoltage and oscillation suppression performance and can significantly reduce the switching losses. [ABSTRACT FROM AUTHOR]

The gallium nitride high electron mobility transistors (GaN HEMTs) are a superior candidate for the new-generation power electronics systems with higher efficiency and power density. However, due to the unique reverse characteristics, the reverse voltage drop of GaN HEMTs is much higher than that of diode. The deadtime loss in GaN-based bridge converters will be comparable to switching losses if the deadtime is not optimized. To optimize the deadtime for higher efficiency, this article proposes an accurate analytical model of GaN HEMTs, including circuit's parasitic inductances, the nonlinear capacitances, the unique reverse characteristics, etc. Taking a GaN-based synchronous buck converter as the example, the proposed model is realized, which fully uses the datasheet to avoid additional experiments. In order to accurately measure the switching current for validation, a novel parasitics-based current measurement method is proposed. The proposed model is verified by simulation in LTspice and experiment, and good agreement is shown. Based on the accurate analytical model, the deadtime is optimized for different load currents to improve the efficiency within the full load range. Compared with the fixed deadtime of 15 ns, the increase of efficiency can be up to 8%. This work will promote the high-frequency application of GaN HEMTs. [ABSTRACT FROM AUTHOR]

Semiconductor devices based solid-state circuit breakers (SSCBs) are promising in the dc power distribution system as protective equipment for their ultrashort action time. This letter proposes a topology of SSCB using series connected silicon carbide (SiC) metal oxide semiconductor field effect transistors (mosfets), which only requires a single isolated gate driver. The SSCB has very low cost and high reliability because it only has 13 components including passive components and diodes apart from two SiC mosfets to achieve both balanced voltage distribution during short-circuit interruption duration and reliable positive gate voltage during on-state. The SSCB prototype is built and experimentally verified to interrupt 75 A short-circuit current under the dc-bus voltage of 1200 V within 1.5 μs. [ABSTRACT FROM AUTHOR]

This paper presents a new active gate drive (AGD) for switching performance improvement and overvoltage protection of high-power insulated gate bipolar transistors (IGBTs). In addition to the conventional gate drive (CGD) based on fixed voltage sources and fixed gate drive resistors, the proposed AGD has a complementary current source to provide extra gate drive current into the gate. Specific transient switching stages of the IGBT can be therefore accelerated, leading to higher switching speed and lower switching loss of the IGBT. Additionally, the turn-off voltage overshoot of the IGBT can be controlled at a preset reference value with a fast closed-loop overvoltage protection circuit. Moreover, the switching speed of the IGBT, including the turn-on/off delay times and the turn-on/off voltage slopes, can be effectively regulated with an adaptive switching speed control method. Accordingly, the gate drive is capable of operating the IGBT at specified delay times and fixed voltage slopes when varying the switching conditions (e.g., temperature, load current). The operation principle of the proposed AGD and control concept are presented. By comparing with the CGD, the proposed method is experimentally verified on a 3.3 kV/1.5 kA IGBT module in both double-pulse and multipulse tests. [ABSTRACT FROM PUBLISHER]

This paper presents a novel compact circuit combining function of gate control and voltage balancing for series-connected silicon carbide (SiC) metal–oxide–semiconductor field-effect transistor (MOSFET). Two series-connected SiC MOSFETs with the proposed circuit only require a single standard gate driver to achieve the gate control and voltage balancing during both steady-state and switching transition. Moreover, the proposed circuit is only composed of ten passive components. Therefore, the proposed circuit provides a low-cost and highly reliable method to increase the blocking voltage of the SiC MOSFET. The operation principles of the proposed circuit are theoretically analyzed. In addition, the high-blocking-voltage device is not only required in switching-mode power supply (SMPS) but also in dc-breaker applications. The proposed circuit is then modified to make it suitable to the dc-breaker applications. The simulation and experimental results validate the effectiveness and superiority of the proposed circuit in both SMPS and dc-breaker applications. [ABSTRACT FROM PUBLISHER]