Search

We report on a passively Q-switched quasi-cw diode-pumped Nd:YAG including an intracavity optical parametric oscillator. The dynamics of this system is described by solving the coupled equations. The effect of the initial transmission of Cr4+:YAG saturable absorber on the signal wave operation is studied. Under optimum conditions, we achieve 2.3 m J energy at 1.57mm wavelength for 40 Hz repetition rate. The peak power of the pulses amounts to 0.88MW with the pulse width of 2.6ns. When the Fresnel reflection losses of the filters are taken into account, the pulse energy would be higher than 2.3 m J. To the best of our knowledge, this is the highest pulse energy and peak power for such a type of single resonant quasi-cw diode pumped Nd:YAG/Cr4+ :YAG IOPO laser. [ABSTRACT FROM AUTHOR]

In this paper a high-repetition-rate mid-infrared (mid-IR) optical parametric oscillator based on periodically poled MgO-doped LiNbO3 (PPMgLN) at room temperature was demonstrated. The maximum average mid-IR output power at 3.63mm was 1.02 W with the repetition rate of 60kHz and corresponding efficiency from the pump to the idler was 26.7%. The temperature tuning and the period tuning characteristics were also discussed. [ABSTRACT FROM AUTHOR]

This paper reports a continuous-wave (CW) mid-infrared intracavity singly resonant optical parametric oscillator based on periodically poled lithium niobate (PPLN) pumped by a diode-end-pumped CW Nd:YVO4 laser. Considering the thermal lens effects, it adopted an optical ballast lens and the near-concentric cavity for better operation. At the PPLN's grating period of 28.5mm and the temperature of 140°C, the maximum idler output power of 155mW at 3.86mm has been achieved when the 808nm pump power is 8.5W, leading to an optical-to-optical conversion efficiency of 1.82%. [ABSTRACT FROM AUTHOR]

Based on a Type II non-critically phase-matched KTA crystal, a low-threshold and high conversion efficiency mid-infrared optical parametric oscillator (OPO) pumped by a diode-end-pumped Nd:YVO4 laser is demonstrated. The OPO threshold is only 0.825 W. The maximum output power of 435mW at 3.47 mm is achieved with the repetition rate of 30 kHz, corresponding to an optical-to-optical conversion efficiency of 4.4%. The photon conversion efficiency is as high as about 64%. The pulse width is 3.5 ns with a peak power of 4kW for the maximum output power. [ABSTRACT FROM AUTHOR]