Search

The advent of additive manufacturing technologies significantly encouraged the development and usage of lattice structures. This paper aims to experimentally investigate the influence of dimension, building position, and orientation on the mechanical properties of Ti6Al4V trusses, manufactured by electron beam melting process, to be used in lattice cells. Specimens were manufactured considering the following parameters: truss diameter (1, 1.5, 2 mm), growth orientation (0°, 45°, 90°), and specimen position inside the building chamber. Trusses with diameter of 1 mm showed inconsistent mechanical properties caused by the poor manufacturing quality. Specimen position was found to influence the analyzed mechanical properties. Unmelted powders were observed to affect the outer surfaces of all specimens and the whole cross-sections of specimens manufactured at 0°. Specimens manufactured at 45° with diameter of 2 mm demonstrated the best performances, whereas specimens manufactured at 90° with diameter of 2 mm displayed the highest elongation at fracture. [ABSTRACT FROM AUTHOR]

The recent improvement of additive manufacturing (AM) technologies has been attracting the industry and research community attention. This paper aims to investigate the influence of building position and printing scheme on the tensile mechanical properties of Tough polylactic acid (PLA) material, manufactured through a fused deposition modeling (FDM) 3D printing – the S5 ProBundle Ultimaker. FDM 3D printing, also known as fused filament fabrication (FFF), is an AM process within the realm of material extrusion. FDM builds parts Layer by Layer by selectively depositing melted material in a predetermined path, and uses thermoplastic polymers that come in the form of filaments. In this paper, AM Tough PLA specimens are manufactured according to ASTM‐D638 requirement considering two different positions on the building plate and two printing schemes. Specimens are tested under static tensile test and the mechanical properties are extracted. [ABSTRACT FROM AUTHOR]