Search

Circular economy plays an essential and useful role in China in considering economic and ecological sustainability. Individual firms, as the primary implements of a circular economy, are facing many obstacles at present in aspects of resource and ecological efficiency. Therefore, this study presents a set of tools to help decision makers better solve these problems and to guide resource-based chemical industries in sustainable development. First, this study describes resource efficiency based on the SFA of a selected P-chemistry firm and identifies the key potential opportunities for improvement using analysis tools and assessment tools. Furthermore, by applying eco-design and decision tools, a firm-level, P-chemical, circular economic system is designed and constructed. A phosphorus chemical optimization model is established, and relevant successive scenarios are generated. Finally, the corresponding feasible solutions and policy recommendations are proposed to improve economic benefit, resource efficiency, waste recycling rate, and eco-efficiency. After industry design, planning, and technological progress, the total economic benefit increases dramatically, and the recycling efficiencies of accompanying resources (F, Si, I, and S) improve by different degrees. The results demonstrate that the economic benefit of phosphorus products increases by 28.5%, and P utilization efficiency correspondingly increases from 81.1% to 94.7%. The comprehensive utilization efficiency of phosphor gypsum increases to 100%, and the eco-efficiency could be improved significantly by eliminating the phosphor gypsum stack. This study demonstrates that technological progress in mineral processing and the production of associated products is the endogenic motivation to increase economic benefit and improve resource efficiency. The method proposed in this paper can be applied, duplicated, and spread not only within the P-chemical industry but also in other resource-based chemical industries. [ABSTRACT FROM AUTHOR]

Abstract: This paper provides analysis of the availability of grain straw resources for centralised industrial usages and suitable areas in China at the prefectural level. China has abundant straw resources for both decentralised and centralised usages. Decentralised usages are inefficient and cannot absorb enough straw. However, centralised usages have technological and economic problems, such as product cost and resource supply, and therefore, a system analysis of the economic available resources and suitable areas are needed. Three main grain crops – rice, wheat, and corn – and three typical centralised usages – paper making, direct combustion power generation, and bioethanol – are investigated in this study. An optimal model is established on the basis of straw resource characteristics and techno-economic characteristics of the usages and used to calculate the distribution of suitable prefectures and the largest supply of resources for each usage. The study focuses on prefectures in 13 provinces with relatively abundant grain straw resources. The suitable areas for paper making are in North China, for direct combustion power generation are in North and Northeast China, for bioethanol are in Northeast China. The largest economic available resources for paper making, direct combustion power generation, and bioethanol are 47.5, 221.4, and 164.4 million tons, respectively. The operation cost and the ratio of straw actually collected from production are selected for conducting a sensitivity analysis. The impacts of other factors, including the geographical environment, local product demand, existing industry, change in total straw production, technical progress and straw from other crops, are discussed. [Copyright &y& Elsevier]

Remanufacturing and direct reuse are considered important measures for promoting the circular economy and improving resource efficiency. Automotive production is a typical resource- and energy-intensive industrial sector, and is a prime market for remanufacturing and direct reuse. Assessing the effect of remanufacturing and direct reuse on the automotive production industry from the perspective of resource efficiency will provide an important reference for improving understandings of remanufacturing and guiding relevant policies in a broader context. A literature review reveals few studies focusing on the resource efficiency of remanufacturing and direct reuse, and the relative lack of a generally accepted indicator to assess the resource efficiency of industrial processes. This paper promotes a new indicator, resource productivity of industrial process , and constructs a material flow model to calculate the resource productivity of China’s automotive industry. Results suggest that the indicator and its analytical model are effective tools to assess resource efficiency. Results also suggest that compared to a case where remanufacturing and direct reuse are not employed, adding these processes in China’s automotive supply chain would increase resource productivity of industrial process by 7.1% in a high efficiency scenario. Based on these findings, policy recommendations for applying the indicator at industry level and encouraging remanufacturing and direct reuse are provided. [ABSTRACT FROM AUTHOR]

China will establish a national emission trading scheme (ETS) in 2017, and the excessive development of coal-to-materials may hinder China′s emission reduction goals, specifically to reduce carbon emissions intensity by 40–45% from 2005 to 2020. In this study, the status of China′s coal-to-materials projects is presented, based on which we forecasted the high, middle and low CO 2 emission scenarios for the coal-to-materials industry in 2020, which were determined to be approximately 580, 290, and 180 Mt CO 2 , respectively. The high scenario is approximately equivalent to the total emission from Canada, the world's 11th-largest emitter in 2014. The main purpose of this study is to research the impacts of ETS on the coal-to-materials industry in 2020. Oil-to-materials is an ineluctable and powerful competitor to the coal-to-materials industry, complicating this matter. Therefore, the Cournot model was applied to quantitatively analyze the competition between these two monopolistic entities and determine the influence of oil, coal and carbon prices on CO 2 emissions from coal-to-materials. The visual simulation of the results shows that ETS can improve the competitiveness of oil-to-materials, resulting in a decline in production of coal-to-materials. However, the effect of the carbon cost with historical price range of Chinese ETS pilots on mitigating CO 2 emissions from the coal-to-materials industry is limited. High oil prices and low coal prices can increase the emissions from coal-to-materials significantly. Our study also provides a tool to analyze the feasibility of ETSs for a set emission reduction goal. Additionally, the necessary sensitivity analysis was also provided. [ABSTRACT FROM AUTHOR]

Abstract: This paper reports China''s eco-efficiency trends and the cause of their dynamic behavior during the period 1978–2010. We show three main results. First, in general, eco-efficiency indicators increased for resource utilization, energy consumption and emissions for air and water, and relative decoupling occurred in China at a high level in the global context. Second, decoupling from economic growth has been absolute for the discharge of soot, chemical oxygen demand (COD) and ammonia nitrogen. Third, during the years 2001–2010, the decoupling level was very low, and resource utilization was almost coupled with GDP due to the high consumption and dramatic increase of mineral extraction. The causes of the observed dynamics of eco-efficiency and decoupling were also explored, with the conclusion drawn that the effect of technology was the predominant positive factor while structure effects were the negative factors for resource and energy efficiency; the technological effect of pipe-end treatment played a dominant role in the improving eco-efficiency of pollutant emissions and decoupling from economic growth. Furthermore, implications for further policymaking to setting proper targets for the relative decoupling of resource use, especially for mineral resource use and economic growth, are suggested. [Copyright &y& Elsevier]

Industrial parks (IPs) have always been an important driving force for China's economic development. China has a great number of IPs, and this number is continuing to increase. The rapid development of IPs has brought great pressure on national resources utilization and environmental protection. The Chinese government has committed to the green development of IPs. In recent years, a series of policies on the green development of IPs have been introduced and implemented. Different from the limitation on the number of IPs in previous studies, this study used a larger data set containing 911 IPs. These IPs were divided into eight types according to their leading industries. The long-tail effect model was attempted to be used to provide quantitative description and analysis of the numerical distribution patterns of the indicators of economic output, environmental pollution, and resource consumption in IPs. Based on the long-tail effect model, for this paper, the performance of green development (PGD) in different types of IPs and IPs in different regions was further analyzed. The results show that China's IPs exhibit the distribution pattern of a long-tail effect in all three aspects mentioned above. In terms of environmental pollution, for some types of IPs, the individual performance of IPs in the head part of the model is more prominent. For other types of IPs, the cumulative results caused by IPs in the tail part of the model should be of concern. The PGD of IPs is closely related to their types. There are also obvious differences in the PGD of IPs in eastern and western China. Based on detailed discussion of the research results, at the end, policy implications are provided for the government to make decisions on the green development of IPs. • Indicators' distribution in China's industrial parks exhibits the long-tail effect. • Green development strategies of industrial parks are related to industrial types. • Focus of green development of industrial parks in east and west China is different. [ABSTRACT FROM AUTHOR]