Search

In recent years, with a large number of distributed energy sources connected to the grid, the distribution network has shown a clear trend towards the use of power electronics. As a power conversion interface, the stability of the converter's interaction with the grid has received considerable attention. Adequate admittance (impedance) modeling of the three‐phase grid‐connected converter is a prerequisite for analyzing the stability and resonance characteristics of the grid‐connected system. Understanding the internal mechanisms and proposing effective solutions are crucial to enable power systems to effectively cope with the impact of power electronics. Therefore, by studying the admittance equivalence relationship and equivalent circuit of three‐phase AC systems in various coordinate systems, this paper focuses on solving the non‐uniqueness problem of impedance admittance modeling of three‐phase converter system. It is proposed that the input admittance of the three‐phase asymmetrical system in the dq and fb rotating coordinate systems is a 2‐order matrix and equivalent. The input admittance of the three‐phase unbalanced system in the αβ and “12” static coordinate systems is a 4‐order matrix and equivalent. From both theoretical analysis and simulation verification, it is shown that the number of eigenvalues of the three‐phase asymmetrical system in the stationary coordinate system is twice that in the rotating coordinate system, and the overall damping of the system is improved. The control strategy based on the stationary coordinate system will make the system more stable. The second contribution of this paper is to establish the equivalent circuit of the three‐phase symmetric converter system by the node admittance matrix and extend it to the multi‐machine system to explain the system instability mechanism by the circuit resonance mechanism. Finally, the frequency coupling phenomenon is studied for the three‐phase asymmetrical converter system, and it is explained that it cannot establish an equivalent circuit similar to the three‐phase symmetrical converter system. [ABSTRACT FROM AUTHOR]

The application of virtual synchronous generators (VSGs) in power systems is gradually increasing to address the low inertia issue caused by the high penetration of renewable energy sources. Besides, the stability of microgrids (MGs) is threatened by constant power loads (CPLs) consisting of power electronic converters with closed‐loop controllers. To investigate the stability of the MG composed of VSG and CPL, this paper analyzes the operational principles of VSG and CPL, revealing that only the bipolar switch logic function is suitable for establishing a closed‐loop model if the output of the inner‐loop controller is considered as the duty cycle of the PWM signal. Furthermore, the closed‐loop impedance models of VSG and CPL were established in the dq frame. Impedance‐based analysis results show that the MG is prone to oscillation in the mid‐band. Therefore, the active power loop parameters of the VSG have a small impact on the stability of the MG, while the LC filter and inner loop controllers have a greater impact on the stability. Based on the oscillation mechanism and passivity theory, the impedance reshaping strategy for VSG and CPL is proposed. It is verified that the proposed control strategy can significantly improve the stability of the MG through the comparison of simulation results and theoretical analysis. [ABSTRACT FROM AUTHOR]