Search

The operation of the system's frequency can be strongly impacted by load change, solar irradiation, wind disturbance, and system parametric uncertainty. In this paper, the application of an adaptive controller based on a hybrid Jaya-Balloon optimizer (JBO) for frequency oscillation mitigation in a single area smart μG system is studied. The proposed adaptive control approach is applied to control the flexible loads such as HPs and EVs by using the JBO which efficiently controls the system frequency. The suggested technique uses the power balance equation to provide a dynamic output feedback controller. The main target is to regulate the frequency and power of an islanded single area μG powered by a PV and a diesel generator with integrations of smart bidirectional loads (HPs and EVs) that are controlled by the proposed adaptive controller in presence of electrical random loads. Moreover, the JBO is designed to minimize the effect of the system load disturbance and parameter variations. For a better assessment, the proposed controller using JBO technique is compared with two other methods which are the coefficient diagram method (CDM) and adaptive one using classical the Jaya technique. In the obtained results, the frequency deviation is found as 0.0015 Hz, which is fully acceptable and in the range of the IEEE standards. The MATLAB simulation results reveal that the suggested technique has a substantial advantage over other techniques in terms of frequency stability in the face of concurrent disturbances and parameter uncertainties. The real-time simulation tests are presented using a dSPACE DS1103 connected to another PC via QUARC pid_e data acquisition card and confirmed the MATLAB simulation results. [ABSTRACT FROM AUTHOR]

The synergetic control technique (SCT) has the solution for understanding the symmetry inherent in the non-linear properties of wind turbines (WTs); therefore, they achieve excellent performance and enhance the operation of the WT. Small-scale WTs are efficient and cost-effective; they are usually installed close to where the generated electricity is used. This technology is gaining popularity worldwide for off-grid electricity generation, such as in rural homes, farms, small factories, and commercial properties. To enhance the efficiency of the WT, it is vital to operate the WT at its maximum power. This work proposes an efficient and fast maximum power point tracking (MPPT) technique based on the SCT to eradicate the drawbacks of the conventional methods and enhance the operation of the WT at the MPP regardless of wind speed and load changes. The SCT has advantages, such as robustness, simplified design, fast response, no requirement for knowledge of WT characteristics, no need for wind sensors or intricate power electronics, and straightforward implementation. Furthermore, it improves speed convergence with minimal steady-state oscillations at the MPP. The investigated configuration involves a wind-driven permanent magnet synchronous generator (PMSG), uncontrolled rectifier, boost converter, and variable load. The two converters are used to integrate the PMSG with the load. Three scenarios (step changes in wind speed, stochastic changes in wind speed, and variable electrical load) are studied to assess the SCT. The results prove a high performance of the suggested MPPT control method for a fast convergence speed, boosted WT efficacy, low oscillation levels, and applicability under a variety of environmental situations. This work used the MATLAB/Simulink program and was then implemented on a dSPACE 1104 control board to assess the efficacy of the SCT. Furthermore, experimental validation on a 1 kW Darrieus-type WT driving a PMSG was performed. [ABSTRACT FROM AUTHOR]