Search

In this work laser‐welded tube‐tube specimens made of aluminium alloys AlMg3.5Mn and AlSi1MgMn T6 were experimentally tested under constant and variable amplitude loading, under pure axial and pure torsion loading. In order to evaluate the influence on fatigue behaviour of the residual stresses, because of the welding process, some specimens were subjected to postweld heat treatment and then were tested. The numerical analyses, using finite element (FE), were carried out to obtain a reliable estimation of the residual stress in the specimen. The numerical results were in a good agreement with experimental ones obtained by means of hole‐drilling method. Finally, the residual stress distribution was superimposed to stress distribution because of fatigue loads obtained by FE analyses applying local concept, to calculate the stresses in the crack initiation zone and to understand the different types of failure that occurred in as‐welded and relieved specimens. [ABSTRACT FROM AUTHOR]

• Exploring post-processing treatments to improve fatigue resistance of LPBF Ti6Al4V. • High pressure heat treatment produced isotropic α + β macrostructure. • Dry electropolishing and sandblasting reduced inherent surface irregularities. • Tensile properties comparable to forged Ti6Al4V used in automotive field. • Fatigue performance is increased with tailored post-processing treatments sequence. This study investigates the impact of post-processing techniques on the fatigue behaviour of specimens in Ti6Al4V made by laser powder bed fusion (LPBF) for relevant applications, such as motorsport. Despite the LPBF advantages in terms of complex design and weight reduction, challenges such as reduced fatigue performance persist. Therefore, the application of post-processing treatments can play a critical role. In addition to traditional sandblasting (SB), three post-processing conditions were investigated to enhance mechanical properties under quasi-static and fatigue loading conditions: heat treatment (HT) and the innovative High Pressure Heat Treatment (HPHT) along with dry electropolishing (EP) treatment. The results indicate that both the HT and HPHT treatments produced a macrostructure with equiaxial grains composed of fine α + β lamellae. Mechanical analyses demonstrated that the HPHT-SB-EP condition exhibits properties comparable to those of forged Ti6Al4V used in the automotive field, with a good balance between strength and ductility. The EP treatment effectively reduced surface roughness and inherent surface irregularities caused by the LPBF process. The best fatigue results were achieved with the HPHT-SB-EP condition, despite data scattering. An increase in fatigue resistance was observed by using SB at a higher pressure. [ABSTRACT FROM AUTHOR]