Search

This paper reports a detailed study on some relevant portions of the main façades of Caserta Royal Palace (Reggia di Caserta), one of the most important Italian monuments, comparable for its impressive architecture to the Royal Palace of Versailles in France and considered the largest royal palace in the world by volume. The research was focused on the weathering pathologies affecting the stone surfaces that, in the last decades, suffered several detachments of fragments from the coatings and from other architectural elements such as string courses, eaves, and capitals. A preliminary characterization of the materials of the façades and an evaluation of the relative weathering pathologies provided the information required for appropriate restoration and securing of these portions of the building. In particular, an innovative evaluation procedure which draws on techniques typical of the earth sciences allowed the proposal of a 'risk attitude' applied to discrete portions of the geomaterials used in the built heritage which is based on the influence of different factors leading to weakening of the stone and to the final detachment of rock fragments. Such a large and complete set of information should be carefully considered by the project planners to adopt the required steps for a suitable risk mitigation and for securing the site during restoration. [ABSTRACT FROM AUTHOR]

The constant increase in consumption of aggregates for concrete production represents a major environmental issue in the construction industry. Recycled wastes might be used as raw materials in the manufacturing of artificial LightWeight Aggregates (LWAs) in substitution and/or in combination with aggregates produced using natural sources for several end-uses, thus saving non-renewable resources. In this study, a Life Cycle Assessment (LCA) is performed for different LWAs manufactured with raw materials supplied by nature or waste. Then, the LCA is conducted on different concretes made of the different LWAs. [ABSTRACT FROM AUTHOR]

Six zeolite-bearing rocks, often used as building materials, were analyzed by thermodilatometry, together with a rock not bearing zeolites and a plaster covering a containing wall made of zeolite-bearing dimension stones, up to 250 °C. The main results obtained were the following: (i) the zeolite-bearing rocks exhibited very small, if any, positive variation of ΔL/Lo (%) up to about 100 °C, whereas they more or less shrank in the temperature range 100–250 °C (final values ranging from −0.21 to −0.92%); (ii) the rock not bearing zeolites regularly expanded through the whole temperature range, attaining a final value of 0.19%; (iii) the plaster showed a thermodilatometric behavior strongly affected by its water content. Obtained results were interpreted based on plain thermal expansion, shrinkage by dehydration, cation migration and thermal collapse of the zeolitic structure. The decay of the zeolite-bearing building materials was essentially related to: (i) the large differences recorded in the thermodilatometric behavior of the various rocks and the plaster; (ii) the different minerogenetic processes that resulted in the deposition of the various zeolite-bearing rocks. [ABSTRACT FROM AUTHOR]

The aim of this research was to develop a new eco-product to find a correct recovery of silicate sawing sludge by means of waste management according to European criteria. To reach this goal, a thermal eco-mortar for a macroporous plaster was developed. The main characteristics of a plaster that influence the correct choice of the mortar are good adherence with underlying support, impermeability, thermal and acoustic insulation, mechanical resistance and ability to allow transpiration processes through the wall's perimeters. Plaster is a mortar composed of a binding part that incorporates sand with a selected particle size distribution, not greater than 2 mm. The sludge, to be used as plaster, must satisfy requirements related to thermal insulation, resistance to moisture, mechanical resistance and good injection. For this purpose, low-content metals sludge, derived from the Luserna stone flaming and cutting slabs, are to be reused as a substitute for the sands and fine particles, respectively, that are normally used to produce plasters. The laboratory tests carried out on the finished product, in accordance with European standards, are as follows: water absorption, specific density, flexural and compressive strength, before and after freeze and thaw cycles, pull out, salt crystallisation cycle resistance and thermal conductivity. Chemical and leaching tests were carried out to verify the possible release of heavy metals into the environment after installation. The product quality was demonstrated as the cement mortars, incorporating the metals, did not allow their release in nature. A sludge recovery, in an unaltered state, was provided to reduce any costs connected to a pre-treatment and to make recovery economically advantageous for the stone sector. [ABSTRACT FROM AUTHOR]