Search

Infragravity (hereafter IG) waves are surface ocean waves with frequencies below those of wind-generated “short waves” (typically below 0.04 Hz). Here we focus on the most common type of IG waves, those induced by the presence of groups in incident short waves. Three related mechanisms explain their generation: (1) the development, shoaling and release of waves bound to the short-wave group envelopes (2) the modulation by these envelopes of the location where short waves break, and (3) the merging of bores (breaking wave front, resembling to a hydraulic jump) inside the surfzone. When reaching shallow water (O(1–10 m)), IG waves can transfer part of their energy back to higher frequencies, a process which is highly dependent on beach slope. On gently sloping beaches, IG waves can dissipate a substantial amount of energy through depth-limited breaking. When the bottom is very rough, such as in coral reef environments, a substantial amount of energy can be dissipated through bottom friction. IG wave energy that is not dissipated is reflected seaward, predominantly for the lowest IG frequencies and on steep bottom slopes. This reflection of the lowest IG frequencies can result in the development of standing (also known as stationary) waves. Reflected IG waves can be refractively trapped so that quasi-periodic along-shore patterns, also referred to as edge waves, can develop. IG waves have a large range of implications in the hydro-sedimentary dynamics of coastal zones. For example, they can modulate current velocities in rip channels and strongly influence cross-shore and longshore mixing. On sandy beaches, IG waves can strongly impact the water table and associated groundwater flows. On gently sloping beaches and especially under storm conditions, IG waves can dominate cross-shore sediment transport, generally promoting offshore transport inside the surfzone. Under storm conditions, IG waves can also induce overwash and eventually promote dune erosion and barrier breaching. In tidal inlets, IG waves can propagate into the back-barrier lagoon during the flood phase and induce large modulations of currents and sediment transport. Their effect appears to be smaller during the ebb phase, due to blocking by countercurrents, particularly in shallow systems. On coral and rocky reefs, IG waves can dominate over short-waves and control the hydro-sedimentary dynamics over the reef flat and in the lagoon. In harbors and semi-enclosed basins, free IG waves can be amplified by resonance and induce large seiches (resonant oscillations). Lastly, free IG waves that are generated in the nearshore can cross oceans and they can also explain the development of the Earth's “hum” (background free oscillations of the solid earth). [ABSTRACT FROM AUTHOR]

We present two independent, automated methods for estimating the absolute horizontal misorientation of seismic sensors. We apply both methods to 44 free-fall ocean-bottom seismometers (OBSs) of the RHUM-RUM experiment (http://www.rhum-rum.net/). The techniques measure the 3-D directions of particle motion of (1) P-waves and (2) Rayleigh waves of earthquake recordings. For P-waves, we used a principal component analysis to determine the directions of particle motions (polarizations) in multiple frequency passbands. We correct for polarization deviations due to seismic anisotropy and dipping discontinuities using a simple fit equation, which yields significantly more accurate OBS orientations. For Rayleigh waves, we evaluated the degree of elliptical polarization in the vertical plane in the time and frequency domain. The results obtained for the RHUM-RUM OBS stations differed, on average, by 3.1° and 3.7° between the methods, using circular mean and median statistics, which is within the methods' estimate uncertainties. Using P-waves, we obtained orientation estimates for 31 ocean-bottom seismometers with an average uncertainty (95 per cent confidence interval) of 11° per station. For 7 of these OBS, data coverage was sufficient to correct polarization measurements for underlying seismic anisotropy and dipping discontinuities, improving their average orientation uncertainty from 11° to 6° per station. Using Rayleigh waves, we obtained misorientation estimates for 40 OBS, with an average uncertainty of 16° per station. The good agreement of results obtained using the two methods indicates that they should also be useful for detecting misorientations of terrestrial seismic stations. [ABSTRACT FROM AUTHOR]