Search

Background and purpose Despite concerns regarding a higher risk of revision, unicompartmental knee arthroplasty (UKA) continues to be used as an alternative to total knee arthroplasty (TKA). There are, however, limited data on the subsequent outcome when a UKA is revised. We examined the survivorship for primary UKA procedures that have been revised. Methods We used data from the Australian Orthopaedic Association National Joint Replacement Registry (AOANJRR) to analyze the survivorship of 1,948 revisions of primary UKA reported to the Registry between September 1999 and December 2008. This was compared to the results of revisions of primary TKA reported during the same period where both the femoral and tibial components were revised. The Kaplan-Meier method for modeling survivorship was used. Results When a primary UKA was revised to another UKA (both major and minor revisions), it had a cumulative per cent revision (CPR) of 28 and 30 at 3 years, respectively. The CPR at 3 years when a UKA was converted to a TKA was 10. This is similar to the 3-year CPR (12) found earlier for primary TKA where both the femoral and tibial components were revised. Interpretation When a UKA requires revision, the best outcome is achieved when it is converted to a TKA. This procedure does, however, have a major risk of re-revision, which is similar to the risk of re-revision of a primary TKA that has had both the femoral and tibial components revised. [ABSTRACT FROM AUTHOR]

Background: Articular Surface Replacement (ASR) hip prostheses, which have metal-on-metal bearing surfaces, were manufactured by DePuy Orthopaedics (Warsaw, Indiana) for use in both conventional total hip arthroplasty and hip resurfacing. Both the ASR XL Acetabular System and the ASR Hip Resurfacing System were recently recalled worldwide by the manufacturer. This report summarizes an analysis by the Australian Orthopaedic Association National Joint Replacement Registry (AOANJRR) of the outcome of arthroplasties involving the ASR prostheses.Methods: The first recorded use of the ASR XL Acetabular System in Australia occurred in 2004, and the Registry recorded 4406 procedures involving this system through December 31, 2009. The first recorded use of the ASR Hip Resurfacing System in Australia occurred in 2003, and the Registry recorded 1167 procedures through December 31, 2009. The Kaplan-Meier method and proportional-hazard modeling were used to compare the revision rate of primary total hip arthroplasties involving the ASR XL Acetabular System with that of arthroplasties involving all other conventional prostheses as well as with that of arthroplasties involving all other conventional prostheses with a metal-on-metal-articulation. In addition, the revision rate of primary arthroplasties involving the ASR Hip Resurfacing System was compared with that of arthroplasties involving all other hip resurfacing prostheses. Patient demographics, prosthesis characteristics, and information regarding the type of revision and the reason for revision were also compared.Results: Arthroplasties involving both ASR designs had a significantly greater revision rate compared with those involving all other prostheses. The cumulative revision rate of arthroplasties involving the ASR XL Acetabular System at five years postoperatively was 9.3% (95% confidence interval [CI], 7.3% to 11.9%) compared with 3.4% (95% CI, 3.3% to 3.5%) for total hip arthroplasties involving all other conventional prostheses. The cumulative revision rate of arthroplasties involving the ASR Hip Resurfacing System at five years postoperatively was 10.9% (95% CI, 8.7% to 13.6%) compared with 4.0% (95% CI, 3.7% to 4.5%) for arthroplasties involving all other resurfacing prostheses. Arthroplasties involving the ASR XL Acetabular System had a greater rate of revision due to implant loosening and/or osteolysis and due to metal sensitivity compared with total hip arthroplasties involving all other conventional prostheses. Arthroplasties involving the ASR XL Acetabular System also had a significantly greater revision rate compared with total hip arthroplasties involving all other conventional metal-on-metal prostheses. Arthroplasties involving the ASR Hip Resurfacing System had a greater rate of revision due to metal sensitivity compared with total hip arthroplasties involving all other resurfacing prostheses.Conclusions: ASR prostheses used in conventional hip arthroplasty and in hip resurfacing exhibited a greater revision rate compared with other prostheses in the AOANJRR. These results are consistent with those derived from other registries and from published studies of individual cohorts. [ABSTRACT FROM AUTHOR]

Background Patella resurfacing in total knee arthroplasty is a contentious issue. The literature suggests that resurfacing of the patella is based on surgeon preference, and little is known about the role and timing of resurfacing and how this affects outcomes. Methods We analyzed 134,799 total knee arthroplasties using data from the Australian Orthopaedic Association National Joint Replacement Registry. Hazards ratios (HRs) were used to compare rates of early revision between patella resurfacing at the primary procedure (the resurfacing group, R) and primary arthroplasty without resurfacing (no-resurfacing group, NR). We also analyzed the outcomes of NR that were revised for isolated patella addition. Results At 5 years, the R group showed a lower revision rate than the NR group: cumulative per cent revision (CPR) 3.1% and 4.0%, respectively (HR = 0.75, p < 0.001). Revisions for patellofemoral pain were more common in the NR group (17%) than in the R group (1%), and 'patella only' revisions were more common in the NR group (29%) than in the R group (6%). Non-resurfaced knees revised for isolated patella addition had a higher revision rate than patella resurfacing at the primary procedure, with a 4-year CPR of 15% and 2.8%, respectively (HR = 4.1, p < 0.001). Interpretation Rates of early revision of primary total knees were higher when the patella was not resurfaced, and suggest that surgeons may be inclined to resurface later if there is patellofemoral pain. However, 15% of non-resurfaced knees revised for patella addition are re-revised by 4 years. Our results suggest an early beneficial outcome for patella resurfacing at primary arthroplasty based on revision rates up to 5 years. [ABSTRACT FROM AUTHOR]

Background and purpose Recent years have seen a rapid increase in the use of resurfacing hip arthroplasty despite the lack of literature on the long-term outcome. In particular, there is little evidence regarding the outcome of revisions of primary resurfacing. The purpose of this analysis was to examine the survivorship of primary resurfacing hip arthroplasties that have been revised. Patients and methods Over 12,000 primary resurfacing hip arthroplasties were recorded by the Australian Orthopaedic Association National Joint Replacement Registry between September 1, 1999 and December 31, 2008. During this time, 397 revisions for reasons other than infection were reported for these primary resurfacings and classified as acetabular, femoral, or both acetabular and femoral revisions. The survivorship of the different types of revisions was estimated using the Kaplan-Meier method and compared using proportional hazard models. Additionally, the outcome of a femoral-only revision was compared to that of primary conventional total hip arthroplasty. Results Acetabular-only revision had a high risk of re-revision compared to femoral-only and both acetabular and femoral revision (5-year cumulative per cent revision of 20%, 7%, and 5% respectively). Femoral-only revision had a risk of re-revision similar to that of revision of both the acetabular and femoral components. Femoral-only revision had over twice the risk of revision of primary conventional total hip arthroplasty. Interpretation Revision of a primary resurfacing arthroplasty is associated with a major risk of re-revision. The best outcome is achieved when either the femoral-only or both the acetabular and femoral components are revised. Technically straightforward femoral-only revisions generally have a worse outcome than a primary conventional total hip arthroplasty. [ABSTRACT FROM AUTHOR]

Background and purpose The outcome of modern resurfacing remains to be determined. The Australian Orthopaedic Association National Joint Replacement Registry (AOANJRR) started collection of data on hip resurfacing at a time when modern resurfacing was started in Australia. The rate of resurfacing has been higher in Australia than in many other countries. As a result, the AOANJRR has one of the largest series of resurfacing procedures. This study was undertaken to determine the results of this series and the risk factors associated with revision. Patients and methods Data from the AOANJRR were used to analyze the survivorship of 12,093 primary resurfacing hip replacements reported to the Joint Replacement Registry between September 1999 and December 2008. This was compared to the results of primary conventional total hip replacement reported during the same period. The Kaplan-Meier method and proportional hazards models were used to determine risk factors such as age, sex, femoral component size, primary diagnosis, and implant design. Results Female patients had a higher revision rate than males; however, after adjusting for head size, the revision rates were similar. Prostheses with head sizes of less than 50 mm had a higher revision rate than those with head sizes of 50 mm or more. At 8 years, the cumulative per cent revision of hip resurfacing was 5.3 (4.6-6.2), as compared to 4.0 (3.8-4.2) for total hip replacement. However, in osteoarthritis patients aged less than 55 years with head sizes of 50 mm or more, the 7-year cumulative per cent revision for hip resurfacing was 3.0 (2.2-4.2). Also, hips with dysplasia and some implant designs had an increased risk of revision. Interpretation Risk factors for revision of resurfacing were older patients, smaller femoral head size, patients with developmental dysplasia, and certain implant designs. These results highlight the importance of patient and prosthesis selection in optimizing the outcome of hip resurfacing. [ABSTRACT FROM AUTHOR]