Search

This study aims to check the compatibility of a selection of waste and recycled biopolymers for rammed earth applications in order to replace the more common cement-based stabilization. Five formulations of stabilized rammed earth were prepared with different biopolymers: lignin sulfonate, tannin, sheep wool fibers, citrus pomace and grape-seed flour. The microstructure of the different formulations was characterized by investigating the interactions between earth and stabilizers through mercury intrusion porosimetry (MIP), nitrogen soprtion isotherm, powder X-ray diffraction (XRD) and scanning electron microscopy (SEM). The unconfined compressive strength (UCS) was also evaluated for all stabilized specimens. Three out of five biopolymers were considered suitable as rammed earth stabilizers. The use of wool increased the UCS by 6%, probably thanks to the combined effect of the length of the fibers and the roughness of their surfaces, which gives a contribution in binding clay particles higher than citrus and grape-seed flour. Lignin sulfonate and tannin increased the UCS by 38% and 13%, respectively, suggesting the additives' ability to fill pores, coat soil grains and form aggregates; this capability is confirmed by the reduction in the specific surface area and the pore volume in the nano- and micropore zones. [ABSTRACT FROM AUTHOR]

• Extended hygrothermal characterization of unstabilized rammed earth. • Low influence of density and grain size distribution on sorption isotherm. • High influence of density on thermal conductivity and vapor resistance factor. • Same linear dependency of thermal conductivity on moisture content for different soil compositions. • Vapor transfer resistance factor for a large span of relative humidity. Although hygrothermal properties of rammed earth represent great potential for improving thermal comfort during hot summers, still little knowledge is available about this topic. The literature lacks complete sets of hygrothermal characteristics of rammed earth, although they are fundamental for heat and moisture transfer modeling necessary to predict earthen building performances. The present work reports the results of a large collaboration between four academic laboratories in order to obtain an extended hygrothermal characterization of rammed earth, focusing on the material used in a modern construction in Lyon, France. The aim of the article is to provide for the same kind of soil an extend characterization on a large span of relative humidity to provide complete set of material properties for heat and moisture transfer simulation. The hygrothermal measurements cover adsorption and desorption isotherm, intermediate isotherm loop, specific heat capacity, dry thermal conductivity, moisture-dependent thermal conductivity and water vapor resistance factor for a large span of relative humidity. In addition, the capillary rise test was performed to estimate the liquid transport coefficient for suction and redistribution. The results show that variations in the density of the samples have a low impact on sorption isotherm, while they have a non-negligible impact on thermal conductivity and water vapor permeability. Surprisingly, variations in the grain size distribution do not produce a significant modification in the sorption isotherm, while hysteresis slightly reduces when bigger grains are added to the soil composition. Approximation of empirical model coefficients for the determination of moisture-dependent thermal conductivity is proposed for rammed earth materials. [ABSTRACT FROM AUTHOR]