Search

Glucose oxidation using platinum promoted by bismuth was studied as a three-phase model reaction. Using catalyst nanoparticles and measuring the oxygen concentration in the bulk liquid, the kinetic parameters and mass transfer characteristics were determined at a temperature of 333 K. The overall reaction rate was studied experimentally using three different support types: slurry catalysts, pellets, and a solid foam stirrer. The glucose conversion rate and the deactivation rate of the catalyst depend strongly on the ratio between mass transfer and reaction rate. At low catalyst concentrations, the glucose oxidation process is liquid–solid mass-transfer-limited. The block stirrer shows a superior performance over the slurry catalysts due to the high liquid–solid volumetric mass transfer coefficient. The bimodal pore size distribution of the catalyst layer further increases the conversion rate. Using slurry catalysts, a loading of 1 wt % in combination with pure oxygen feed is required to achieve acceptable conversion rates. Under these conditions, the gas–liquid mass transfer and partially the liquid–solid mass transfer are the rate-limiting steps. The foam block stirrer shows good gas–liquid mass transfer rates and high liquid–solid mass transfer rates, which still increase at high power input. Working under external mass transfer control and using this stirrer type, the catalyst loading can be strongly reduced to loadings less than 0.4 wt %, while the conversion rate remains comparable to slurry particles with loadings of 1 wt %. As the catalyst is fixed, attrition and agglomeration in high viscosity liquids are circumvented. There is further no need for filtration, and the catalyst can simply be reused. [ABSTRACT FROM AUTHOR]

A Cu/PMA-MIL-101(Cr) metal-organic-framework-coated microreactor has been applied in the 1,3-dipolar cycloaddition of benzyl azide and phenylactetylene (click chemistry). The Cu/PMA-MIL-101(Cr) catalyst was incorporated by using a washcoating method. The use of tetraethylorthosilicate (TEOS) and a copolymer pluronic F127 as binders resulted in a stable and uniform coating of 6 μm. The application of the Cu/PMA-MIL-101(Cr) capillary microreactor in the click-chemistry reaction resulted in a similar intrinsic activity as in the batch reactor, and a continuous production for more than 150 h time-on-stream could be achieved. The presence of water in the reagent feed led to reversible catalyst deactivation and was necessary to be removed to obtain a stable catalyst operation. [ABSTRACT FROM AUTHOR]