Search

The upcoming UCNProBe experiment at Los Alamos National Laboratory will measure the beta decay rate of free neutrons with different systematic uncertainties than previous beam-based neutron lifetime experiments. We have tested a new 10B-coated Yttrium Aluminum Perovskite (YAP:Ce) scintillator and present its properties. The advantages of the YAP:Ce scintillator include its high Fermi potential, which reduces the probability for upscattering of ultracold neutrons (UCN), and its short decay time, which increases sensitivity at high counting rates. Birks' coefficient of YAP:Ce was measured to be (5.5 6 − 0.30 + 0.05 ) × 1 0 − 4 cm/MeV. The loss of light due to the 120 nm 10B-coating was measured to be about 60%, and the loss of light from YAP:Ce due to transmission through a deuterated polystyrene scintillator was about 50%. The efficiency for neutron capture on the 10B coating was (86.8 ± 2.6)%, and a measurement using UCN showed that the YAP:Ce crystal counted 8%–28% more UCN compared to a ZnS:Ag screen. The difference may be due to the uneven coating of 10B on the rough surface of ZnS:Ag. [ABSTRACT FROM AUTHOR]

A study of the dead layer thickness and quenching factor of a plastic scintillator for use in ultracold neutron (UCN) experiments is described. Alpha spectroscopy was used to determine the thickness of a thin surface dead layer to be 630 ± 110 nm. The relative light outputs from the decay of 241Am and Compton scattering of electrons were used to extract Birks' law coefficient, yielding a kB value of 0.087 ± 0.003 mm/MeV, consistent with some previous reports for other polystyrene-based scintillators. The results from these measurements are incorporated into the simulation to show that an energy threshold of (∼9 keV) can be achieved for the UCNProBe experiment. This low threshold enables high beta particle detection efficiency and the indirect measurement of UCN. The ability to make the scintillator deuterated, accompanied by its relatively thin dead layer, gives rise to unique applications in a wide range of UCN experiments, where it can be used to trap UCN and detect charged particles in situ. [ABSTRACT FROM AUTHOR]

In this paper, we report studies of the Fermi potential and loss per bounce of ultracold neutrons (UCNs) on a deuterated scintillator (Eljen-299-02D). These UCN properties of the scintillator enable its use in a wide variety of applications in fundamental neutron research. [ABSTRACT FROM AUTHOR]

We describe the design, construction, and performance of three generations of superconducting Ioffe magnetic traps. The first two are low current traps, built from four racetrack shaped quadrupole coils and two solenoid assemblies. Coils are wet wound with multifilament NbTi superconducting wires embedded in epoxy matrices. The magnet bore diameters are 51 and 105 mm with identical trap depths of 1.0 T at their operating currents and at 4.2 K. A third trap uses a high current accelerator-type quadrupole magnet and two low current solenoids. This trap has a bore diameter of 140 mm and tested trap depth of 2.8 T. Both low current traps show signs of excessive training. The high current hybrid trap, on the other hand, exhibits good training behavior and is amenable to quench protection. [ABSTRACT FROM AUTHOR]

Fornal and Grinstein recently proposed that the discrepancy between two different methods of neutron lifetime measurements, the beam and bottle methods, can be explained by a previously unobserved dark matter decay mode, n→X+γ. We perform a search for this decay mode over the allowed range of energies of the monoenergetic γ ray for X to be dark matter. A Compton-suppressed high-purity germanium detector is used to identify γ rays from neutron decay in a nickel-phosphorous-coated stainless-steel bottle. A combination of Monte Carlo and radioactive source calibrations is used to determine the absolute efficiency for detecting γ rays arising from the dark matter decay mode. We exclude the possibility of a sufficiently strong branch to explain the lifetime discrepancy with 97% confidence. [ABSTRACT FROM AUTHOR]

Research efforts ranging from studies of solid helium to searches for a neutron electric dipole moment require isotopically purified helium with a ratio of ³He to 4He at levels below that which can be measured using traditional mass spectroscopy techniques. We demonstrate an approach to such a measurement using accelerator mass spectroscopy, reaching the 10-14 level of sensitivity, several orders of magnitude more sensitive than other techniques. Measurements of ³He/4He in samples relevant to the measurement of the neutron lifetime indicate the need for substantial corrections. We also argue that there is a clear path forward to sensitivity increases of at least another order of magnitude. [ABSTRACT FROM AUTHOR]