Search

This paper presents the design, fabrication, and characterization of two compact fiber-optic current sensors (FOCS) based on fiber Bragg gratings (FBG) and the magnetostrictive alloy Terfenol-D. Finite-element-method (FEM) simulations assisted key optimizations in the geometry of similar FOCS proposed previously, allowing the implementation of magnetic flux density concentration techniques that resulted in sensors using very small amounts of Terfenol-D. Two prototypes of FOCS with the same geometry and size were manufactured for performance comparison purposes, one using a 2.21-g solid, bulk bar of Terfenol-D onto which a sensing FBG was bonded, and the other using magnetostrictive polymer composite (MPC) with oriented magnetic domains using only 0.42 g of Terfenol-D powder and epoxy resin with a sensing FBG embedded within the composite block. Both FOCS were characterized with currents of up to 800 Arms, and presented linearity errors smaller than 1% of full-scale range (FSR). The prototypes presented greater sensitivities taking into account that only less than 6% of Terfenol-D was employed in comparison to previous FBG-based FOCS. Transient-responses of the FOCS prototypes were also measured showing that the proposed sensors might be applied not only to current metering, but also to fault detection in high-voltage lines. Temperature compensation methods were also proposed and discussed for the developed FOCS. [ABSTRACT FROM AUTHOR]

We present in this paper a method and apparatus for nonintrusive measurement of active energy in low-voltage ac installations. In the proposed method, the active power is calculated from the voltage and current waveforms, and the phase shift between them. No voltage amplitude measurement is required since the nominal voltage of the ac installation is considered as the actual voltage. This approach bypasses the main disadvantage of capacitive ac voltage probing: low accuracy in amplitude measurements due to variations on the sensor coupling capacitance. The energy meter that implements the technique is composed of a commercial nonintrusive current sensor (clamp-on current transformer) and a contactless capacitive voltage sensor—designed to measure the voltage phase and waveform. The voltage sensor includes a shield to isolate it from external electric fields, making the energy meter suitable for applications in polyphase systems. The developed energy meter does not require on-site calibration, galvanic contact to the phase conductors, neither electrical circuit opening, allowing for quick, safe, and easy installation on overhead service drop line. Due to these characteristics, it can be used by electricity distribution companies in the preinspection of consumer units suspected of fraud. Experimental results proved that the developed energy meter is insensitive to the characteristics of cables (width and insulation), external electrical fields, as well as to the voltage sensor capacitance variations. The error of the active energy measurement under real condition in a two-phase installation was 1%. [ABSTRACT FROM AUTHOR]