Search

Magnetoresistive (MR) sensors have great application prospects in the field of weak magnetic field detection due to their high sensitivity, small size, and low power consumption. However, 1/f noise greatly limits the low-frequency detectivity of MR sensors. In order to suppress 1/f noise, this paper proposes a two-dimensional synchronous motion modulation (TDSMM) structure based on microelectromechanical systems (MEMS). This structure can effectively reduce 1/f noise by modulating the frequency of the measured magnetic field in the high-frequency band. Theoretical analysis and finite element simulation were conducted on three different modulation models: TSDMM, magnetic flux concentrators motion modulation, and MR components longitudinal motion modulation. The results showed that the modulation efficiency of the TDSMM reached as high as 127%, which is currently the highest value in MR-MEMS sensors. The TDSMM MEMS structure has been successfully manufactured, and the resonant frequency of the transverse resonator is twice that of the longitudinal resonator, enabling extremely high modulation efficiency. The noise spectral density of giant-magnetoresistive components on a silicon-on-insulator substrate was tested, and the noise level in the high-frequency band was three orders of magnitude lower than that in the low-frequency band. These results position MR-MEMS sensors with TDSMM structures as highly competitive candidates in the field of ultra-weak magnetic field detection. [ABSTRACT FROM AUTHOR]

Microelectromechanical system (MEMS) resonators have been widely used in the magneto-resistive (MR) sensor for modulating the magnetic flux to enhance the detection limit. However, the manufacturing tolerances in MEMS fabrication processes make it challenging to fabricate the identical resonators with the same vibration frequency, which greatly decreases the detection limit of the MR sensor. To synchronize the MEMS resonators and improve the performance of the MR sensor, the double-ended tuning fork (DETF) based comb-driven MEMS resonators is proposed in this paper, making the system operate at the out-of-phase mode to complete the synchronization. The dynamic behaviour of the resonators is investigated through theoretical analysis, numerical solution based on MATLAB code and Simulink, and experimental verification. The results show that the transverse capacitances in the comb will significantly affect the resonance frequency due to the second-order electrostatic spring constant. It is the first time to observe the phenomenon that the resonant frequency increases with the increase of the bias, and it can also decrease with increasing the bias through adjusting the initial space between the fixed finger and the moving mass, they are different from the model about spring softening and spring hardening. Besides, the proposed DETF based comb-driven resonators can suppress the in-phase and out-of-phase mode through adjusting the driving and sensing ports, and sensing method, meanwhile make the magnetic flux modulation fully synchronized, and maximize the modulation efficiency, and minimize the detection limit. These characteristics are appropriate for the MR sensor, even other devices that need to adjust the resonance frequency and vibration amplitude. Furthermore, the model and the design can also be extended to characteristic the single end tuning fork based MEMS resonator and other MEMS-based MR sensors. [ABSTRACT FROM AUTHOR]