Search

An in-fiber Mach–Zehnder Interferometer (MZI), based on hollow core fiber (HCF), for measuring curvature is fabricated and experimentally demonstrated. The sensing part was fabricated by splicing a section of HCF between two sections of multimode fiber (MMF), and different HCF lengths were investigated in order to achieve the highest curvature sensitivity. These devices were tested in a transmission configuration using lead-in and lead-out single mode fibers (SMF). The sensor was attached to a steel sheet by using the polymer Polydimethylsiloxane (PDMS) for accurate control of the applied curvature. The modal analysis was carried out using a commercial software based on finite element method (FEM) and by incorporating some of the experimental data, it was feasible to determine the two dominant modes that interfere in this sensor. The devices were characterized by measuring the fringe contrast variations due to the curvature changes. The interferometer fabricated with a HCF 2.5 mm in length HCF showed the highest curvature sensitivity, −17.28 ± 2.30 dB/m−1, in a range from 1.84 m−1 to 2.94 m−1. Moreover, the sensor that exhibited a better performance was fabricated with a HCF length of 1 mm, combining the most extensive curvature range (from 0.95 m−1 to 2.68 m−1) and an adequate sensitivity (−11.80 ±1.30 dB/m−1). The analysis of the interferometric signal of this device in Fourier domain, allows us to establish a one to one relationship between the contrast and the curvature in a broader range (from 0 m−1 to 2.94 m−1). Moreover, the fringe contrast showed a very low dependency on temperature (from 30 °C to 90 °C), depicting that this device was not affected by temperate fluctuation. [ABSTRACT FROM AUTHOR]

In this paper, we demonstrate highly sensitive refractive index (RI) sensing based on multicore coupled structures. Specifically, we use a seven-core fiber (SCF) as the sensing element. The interaction of the SCF and its surroundings is induced by controllably etching material from the cladding in order to expose its external cores. Thus, the sensor sensitivity can be tuned by simply controlling the etching depth. In our case, the cladding of a 10-mm-long piece of SCF, spliced between two single-mode fibers, was slowly removed until the remaining cladding around the external cores is only 2.5 μm. Sensitivity on the order of 1 × 104 nm/RIU is experimentally demonstrated. These sensing architectures are compact, all-fiber, simple to fabricate, and highly sensitive. Based on our results RI changes of 10–4–10–5 can be resolved with standard laboratory-graded equipment, which opens the possibility of using this type of sensing architectures in biological applications. [ABSTRACT FROM PUBLISHER]

A simple and compact fiber optic sensor based on a two-core fiber is demonstrated for high-performance measurements of refractive indices (RI) of liquids. In order to demonstrate the suitability of the proposed sensor to perform high-sensitivity sensing in a variety of applications, the sensor has been used to measure the RI of binary liquid mixtures. Such measurements can accurately determine the salinity of salt water solutions, and detect the water content of adulterated alcoholic beverages. The largest sensitivity of the RI sensor that has been experimentally demonstrated is 3,119 nm per Refractive Index Units (RIU) for the RI range from 1.3160 to 1.3943. On the other hand, our results suggest that the sensitivity can be enhanced up to 3485.67 nm/RIU approximately for the same RI range. [ABSTRACT FROM AUTHOR]