Search

Titanium and titanium nitride layers were alternately sputtered on a high resistivity silicon wafer to obtain a multilayer film structure, for a total thickness ranging between 34 and 180 nm. The electrical resistance of the Ti/TiN film was characterized from room temperature down to the superconducting transition. Both the resistivity just above the transition and the critical temperature were investigated as a function of the total film thickness and the single TiN layer thickness, respectively. The obtained resistivity range is 67–312 μΩ cm. Exploiting the proximity effect, we were able to tune the critical temperature in the 0.29–4.5 K range. A comparison between experimental data and theoretical models is proposed in order to facilitate the a priori design of superconducting detectors. [ABSTRACT FROM AUTHOR]

We present a method to search for transient gravitational waves using a network of detectors with different spectral and directional sensitivities: the interferometer Virgo and the bar detector AURIGA. The data analysis method is based on the measurements of the correlated energy in the network by means of a weighted cross-correlation. To limit the computational load, this coherent analysis step is performed around time-frequency coincident triggers selected by an excess power event trigger generator tuned at low thresholds. The final selection of gravitational wave candidates is performed by a combined cut on the correlated energy and on the significance as measured by the event trigger generator. The method has been tested on one day of data of AURIGA and Virgo during September 2005. The outcomes are compared to the results of a stand-alone time-frequency coincidence search. We discuss the advantages and the limits of this approach, in view of a possible future joint search between AURIGA and one interferometric detector. [ABSTRACT FROM AUTHOR]

The first simultaneous operation of the AURIGA detector and the LIGO observatory was an opportunity to explore real data, joint analysis methods between two very different types of gravitational wave detectors: resonant bars and interferometers. This paper describes a coincident gravitational wave burst search, where data from the LIGO interferometers are cross-correlated at the time of AURIGA candidate events to identify coincident transients. The analysis pipeline is tuned with two thresholds, on the signal-to-noise ratio of AURIGA candidate events and on the significance of the cross-correlation test in LIGO. The false alarm rate is estimated by introducing time shifts between data sets and the network detection efficiency is measured by adding simulated gravitational wave signals to the detector output. The simulated waveforms have a significant fraction of power in the narrower AURIGA band. In the absence of a detection, we discuss how to set an upper limit on the rate of gravitational waves and to interpret it according to different source models. Due to the short amount of analyzed data and to the high rate of non-Gaussian transients in the detectors' noise at the time, the relevance of this study is methodological: this was the first joint search for gravitational wave bursts among detectors with such different spectral sensitivity and the first opportunity for the resonant and interferometric communities to unify languages and techniques in the pursuit of their common goal. [ABSTRACT FROM AUTHOR]