Search

Copyright of Scientific Papers of Silesian University of Technology. Organization & Management / Zeszyty Naukowe Politechniki Slaskiej. Seria Organizacji i Zarzadzanie is the property of Silesian Technical University, Organisation & Management Faculty and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

In this study, the mixing power and the axial and radial velocity distributions were determined for the standard PBT45-6 impeller with inclined blades and for three NACA impellers with airfoil blades. On the basis of the velocity distributions obtained by means of PIV techniques, the pumping efficiency and the size of the secondary circulation for the tested impellers were determined. The next stage was to calculate the efficiency of the impeller operation, in which the comparative criteria were the values of the mixing energy in the form of a dimensional and dimensionless criterion. The lowest mixing energy was obtained for impellers with symmetrical profiled NACA0021 blades, which was 20% lower than the similar mixing energy obtained for the standard PBT45-6 impeller. [ABSTRACT FROM AUTHOR]

This paper presents an analysis of methods to increase the efficiency of heat transfer in heat exchangers. The scope of the research included analysis of efficiency optimization using the example of two tubular heat exchanger structures most often used in industry. The obtained efficiency of heat recovery from the ground of the examined exchangers was over 90%, enabling the reduction of emissions of the heating systems of buildings. The paper presents the results of tests of two types of heat pipes using R134A, R404A, and R407C working agents. The paper also presents the results of experimental tests using the R410A working medium. The results included in the study will also enable the effective use of land as a heat store. [ABSTRACT FROM AUTHOR]

The paper presents research on the phenomenon of an increase in mixing power during the emptying of a tank with two 6-PBT45° axial impellers in operation, located on a common shaft, pumping the liquid to the bottom of the mixing tank. A large increase in mixing power took place when the free surface of the liquid was just above the upper edge of one of the impellers (hp/D < 0.1). This increase was even more than 50% compared to the design power for a fully filled mixing vessel. Admittedly, high motor overload, while not very long, may damage it. The study investigated the instantaneous torques acting on the impeller shaft during the emptying of the tank and the velocity distributions in planes r-z. On their basis, the mechanism of the phenomenon observed was determined and correlation relationships were given that permitted the calculation of the numerical values of the power increase factors. [ABSTRACT FROM AUTHOR]

This paper presents an analysis of hydrodynamics in a tank with a 45° and 60° pitched blade turbine impeller operating while emptying the mixer and with an axial agitator working during axial pumping-down of water at different water levels above the impeller. Measurements made with the PIV method confirmed the change in direction of pumping liquid after the level dropped below the critical value, with an almost unchanged liquid stream flowing through the mixer. It was found that an increase in the value of the tangential velocity in the area of the impeller took place and the quantity of this increase depended on the angle of the blade pitch and the rotational frequency of the impeller. Change in this velocity component increased the mixing power. [ABSTRACT FROM AUTHOR]