Search

Future industrial applications of microparticle fractionation with deterministic lateral displacement (DLD) devices are hindered by exceedingly low throughput rates. To enable the necessary high-volume flows, high flow velocities as well as high aspect ratios in DLD devices have to be investigated. However, no experimental studies have yet been conducted on the fractionation of bi-disperse suspensions containing particles below 10 µm with DLD at a Reynolds number (Re) above 60. Furthermore, devices with an aspect ratio of more than 4:1, which require advanced microfabrication, are not known in the DLD literature. Therefore, we developed a suitable process with deep reactive ion etching of silicon and anodic bonding of a glass lid to create pressure-resistant arrays. With a depth of 120 µm and a gap of 23 µm between posts, a high aspect ratio of 6:1 was realized, and devices were investigated using simulations and fractionation experiments. With the two-segmented array of 3° and 7° row shifts, critical diameters of 8 µm and 12 µm were calculated for low Re conditions, but it was already known that vortices behind the posts can shift these values to lower critical diameters. Suspensions with polystyrene particles in different combinations were injected with an overall flow rate of up to 15 mL/min, corresponding to Re values of up to 90. Suspensions containing particle combinations of 2 µm with 10 µm as well as 5 µm with 10 µm were successfully fractionated, even at the highest flow rate. Under these conditions, a slight widening of the displacement position was observed, but there was no further reduction in the critical size as it was for Re = 60. With an unprecedented fractionation throughput of nearly 1 L per hour, entirely new applications are being developed for chemical, pharmaceutical, and recycling technologies. [ABSTRACT FROM AUTHOR]

Deterministic lateral displacement (DLD) is a high-resolution passive microfluidic separation method for separating micron-scale particles according to their size. Optimizing these microsystems for larger throughputs and particle concentrations is of interest for industrial applications. This study evaluates the limitations of the functionality of the DLD separation principle under these specific conditions. For this reason, different particle volume fractions (up to 11%) and volumetric flow rates (corresponding to Reynolds numbers up to 50) were varied within the DLD microsystem and tested in different combinations. Resolved two-way coupled computational fluid dynamics/discrete element method (CFD-DEM) simulations including spherical particles were performed. The results show a general increase in the critical diameter with increasing volume fraction and decreasing separation efficiency. The largest tested Reynolds number (Re = 50) results in the highest separation efficiency, particularly at low volume fractions, and is only slightly less efficient than low Reynolds numbers as the volume fraction increases. The results indicate that by limiting the volume fraction to a maximum of 3.6%, the flow rate and the associated separation rate can be increased while maintaining a high separation efficiency. [ABSTRACT FROM AUTHOR]

Deterministic lateral displacement (DLD) microsystems are suitable for the size fractionation of particle suspensions in the size range of 0.1 to 10 µm. To be able to fractionate real particles beyond a laboratory scale, these systems have to be designed for higher throughputs. High flow resistances and increasing the clogging of the systems impose substantial challenges for industrial operation. Simulative parameter studies are suitable for improving the design of the systems; for example, the position and shape of the posts. A high-resolution, two-way coupled 6-DOF CFD-DEM approach was used to study the flow and particle behavior of different post shapes (circular and triangular) and post sizes at different Reynolds numbers. The results were compared with the classical first streamline width theory. It was shown that the streamline theory does not account for all effects responsible for the separation. Furthermore, a shift in the critical particle diameter to smaller values could be obtained when increasing the Reynolds number and also when using triangular posts with reduced post sizes compared to the post spacing. These findings can help to improve the efficiency of the systems as the post spacing could be extended, thus reducing the flow resistance and the probability of clogging. [ABSTRACT FROM AUTHOR]