Search

A method where particulates are transferred via a cosmetic brush onto liquid drops created on a highly non-wetting substrate with a hole to generate talc and graphite liquid marbles (LMs) and talc-graphite Janus liquid marbles is described. van der Waals forces facilitated the attachment of particulates to the dry brush bristles. Subsequently, the surface tension forces that developed from particle interaction with water (which were O(102) higher than the van der Waals forces) could then engender transfer of the particulates to the liquid-gas interface of the drop. Forces below 1 mN applied by a dangling foil on the LM ensured preservation of the drop shape when the force was removed. During the application of this force, the contact angles at the contact lines behaved differently from sessile drops that are inclined on surfaces. This preparation method portends the ability to automate the creation of LMs and Janus LMs for various applications.

Digital microfluidics, which relies on the movement of drops, is relatively immune to clogging problems, making it suited for micro-reactor applications. Here, graphene oxide paper of 100 μm thickness, fabricated by blade coating sedimented dispersions onto roughened substrates, followed by drying and mechanical exfoliation, was found to be relatively free of cracks and curling. It also exhibited high wettability and elasto-capillary characteristics. Possessing low enough stiffness, it could rapidly and totally self-wrap water drops of 20 μL volume placed 2 mm from its edge when oriented between 0 and 60° to the horizontal. This complete wrapping behavior allowed drops to be translated via movement of the paper over long distances without dislodgement notwithstanding accelerations and decelerations. An amount of 2 drops that were wrapped with separate papers, when collided with each other at speeds up to 0.64 m/s, were found to eschew coalescence. This portends the development of robust digital microfluidic approaches for micro-reactors.

A facile one-step method of roughened copper foils of 0.0076 ​mm thickness heated on the open flame for 15 ​s produced superhydrophilic surfaces that exhibited superwetting at average radial growths of 10.8 ​mm/s following drop dispensation. Superhydrophilicity was found to deteriorate over time and XRD analysis ruled out compositional change as the cause of this behaviour. Instead, SEM imaging revealed wrinkled 20–30 ​nm-thick nanoflakes that were predominantly stretched out initially to engender superwetting properties via Wenzel wetting. These extended microstructures folded up with time due to relaxation of the residual stresses from the thermal oxidation process, resulting in temporal reduction in superhydrophilicity, which can be restored by reapplying thermal oxidation. The impingement of air with 80 psi pressure on the substrate also caused similar deterioration. The superwetting characteristic also endowed these substrates with anti-bacterial properties where a 56% reduction in bacteria count with Staphylococcus epidermidis was found.

A two-component liquid drop is generated over a hole on a superhydrophobic substrate. When a 6 V electrolysis voltage was applied to the overhanging component of the liquid drop, bubbles of oxygen and hydrogen at rates of 0.0025 and 0.045 mm3/s respectively were produced. Positioning the electrode beneath the hole allowed the gas bubbles to travel upwards by buoyancy into the overhead liquid component for aeration. The bubbles broke-up into smaller sizes, which would facilitate gas diffusion to the liquid phase, and populated the apex of the overhead component.