Search

Liquefied natural gas (LNG) use as shipping fuel has increased in recent years. While LNG results in lower carbon dioxide (CO2) emissions as well as benefits in terms of air pollutants, the slip of unburned methane, the main component of LNG, has remained a concern. In this study, methane together with other climate warming agents, CO2 and black carbon (BC), as well as other emission compounds were characterized from 4-stroke low-pressure dual fuel engine on-board a newly build cruise ship utilizing LNG as well as marine gas oil (MGO). The brake specific methane slip was found to vary according to engine load, being 2.3–3.0 g/kWh at 54–80% loads, but increasing to 10 g/kWh at 25% load and 21 g/kWh at 12% load. The LNG combustion also resulted in higher formaldehyde emissions compared to MGO, but reduction in formaldehyde levels was observed over the SCR catalyst present in the exhaust line of the dual-fuel engine, without urea injection, suggesting it may provide a pathway for formaldehyde mitigation. In terms of particle emissions, LNG use reduced particle mass (PM) by 87–93% and BC by 94–99% compared to MGO combustion. Non-volatile particle number above 23 nm (PNnv,>23nm) and 10 nm (PNnv,>10nm) were reduced by 88–97% and 97–99%, except at lowest engine load where PNnv,>10nm increased by 26% compared to MGO utilization. When total greenhouse gas (GHG) emissions including CO2 and BC were considered, LNG use resulted in 13–15% lower GHG at high loads, but the benefit was undermined by the escaping methane at low load conditions. Following the engine activity profile during 8-months of vessel operation on the Mediterranean suggested, however, that in a diesel-electric cruise ship, low load conditions are used mainly during arrivals and departures from harbors, as the engine was operated at loads above 40% for 90% of the operation time. Weighted emission factor, representing the actual engine operation, resulted in methane slip of 2.8 g/kWh or 1.7% of the fuel use, which is below the value considered in the FuelEU Maritime. The results suggest that load specific methane slip, together with engine load profile should be considered when evaluating methane slip on vessel or fleet level.

Natural gas usage in the traffic and energy production sectors is a growing trend worldwide; thus, an assessment of its effects on air quality, human health and climate is required. Engine exhaust is a source of primary particulate emissions and secondary aerosol precursors, which both contribute to air quality and can cause adverse health effects. Technologies, such as cleaner engines or fuels, that produce less primary and secondary aerosols could potentially significantly decrease atmospheric particle concentrations and their adverse effects. In this study, we used a potential aerosol mass (PAM) chamber to investigate the secondary aerosol formation potential of natural gas engine exhaust. The PAM chamber was used with a constant UV-light voltage, which resulted in relatively long equivalent atmospheric ages of 11 days at most. The studied retro-fitted natural gas engine exhaust was observed to form secondary aerosol. The mass of the total aged particles, i.e., particle mass measured downstream of the PAM chamber, was 6–268 times as high as the mass of the emitted primary exhaust particles. The secondary organic aerosol (SOA) formation potential was measured to be 9–20 mg kgfuel−1. The total aged particles mainly consisted of organic matter, nitrate, sulfate and ammonium, with the fractions depending on exhaust after-treatment and the engine parameters used. Also, the volatility, composition and concentration of the total aged particles were found to depend on the engine operating mode, catalyst temperature and catalyst type. For example, a high catalyst temperature promoted the formation of sulfate particles, whereas a low catalyst temperature promoted nitrate formation. However, in particular, the concentration of nitrate needed a long time to stabilize – more than half an hour – which complicated the conclusions but also indicates the sensitivity of nitrate measurements on experimental parameters such as emission source and system temperatures. Sulfate was measured to have the highest evaporation temperature, and nitrate had the lowest. The evaporation temperature of ammonium depended on the fractions of nitrate and sulfate in the particles. The average volatility of the total aged particles was measured to be lower than that of primary particles, indicating better stability of the aged natural gas engine-emitted aerosol in the atmosphere. According to the results of this study, the exhaust of a natural gas engine equipped with a catalyst forms secondary aerosol when the atmospheric ages in a PAM chamber are several days long. The secondary aerosol matter has different physical characteristics from those of primary particulate emissions.